The installation is done in three steps: 1. Installation of the board 2. Updating the boot loader 3. Updating I32/PRE32 Firmware via RS232 Primare AB • Limstensgatan 7 • SE-21616 Limhamn • Sweden • Tel +46 40 654 88 00 • www.primare.net...
1.2 Unscrew the two screws holding the plate in place 1.3 Slide in the MM30 board until the boards CLICKS in place 1.4 Put both screws back in place Primare AB • Limstensgatan 7 • SE-21616 Limhamn • Sweden • Tel +46 40 654 88 00 • www.primare.net...
2.14 Continue with step 3. Updating I32/PRE32 Firmware via RS232 on the next page. Primare AB • Limstensgatan 7 • SE-21616 Limhamn • Sweden • Tel +46 40 654 88 00 • www.primare.net...
More info about updating your firmware in the following chapters: 4. Updating I32/PRE32/MM30 firmware via Internet 5. Updating I32/PRE32/MM30 Firmware via USB Primare AB • Limstensgatan 7 • SE-21616 Limhamn • Sweden • Tel +46 40 654 88 00 • www.primare.net...
Enter the ‘Firmware settings’ again. This time you will find the menu a little bit different. The unit will automatically scan for new firmware when in ’Firmware settings’. Primare AB • Limstensgatan 7 • SE-21616 Limhamn • Sweden • Tel +46 40 654 88 00 • www.primare.net...
Page 7
If you encounter problems with updating the ‘Network’ firmware, please see document MM30 NET Firmware upgrade - Instruction (Public).pfd Located on our website under Support -> I32/PRE32/MM30 Primare AB • Limstensgatan 7 • SE-21616 Limhamn • Sweden • Tel +46 40 654 88 00 • www.primare.net...
5.8 When the installation is complete, the unit will turn itself OFF. 5.9 Start the unit, go to ‘Firmware settings’ and press ‘Scan for firmware’, and choose USB Primare AB • Limstensgatan 7 • SE-21616 Limhamn • Sweden • Tel +46 40 654 88 00 • www.primare.net...
Page 9
Note that only I32/PRE32 firmware and MM30 firmware can be updated via USB. Network firmware can only be updated via Internet. Please see 4.10 for instructions. END. Primare AB • Limstensgatan 7 • SE-21616 Limhamn • Sweden • Tel +46 40 654 88 00 • www.primare.net...
Need help?
Do you have a question about the MM30 and is the answer not in the manual?
Questions and answers