Advertisement
Table of Contents
- 1 Connect HDMI Display
- 2 Connect a USB Keyboard and Mouse
- 3 Connect the 12V DC Power Supply
- 4 Power on the FPGA Board (Rear Switch)
- 5 Turn on the Power of the CPU Board (Front Switch)
- 6 Set up the Linux Desktop on the Display Monitor
- 7 Perform FPGA Opencl DDR4 Read and Write Tests
- Download this manual
Quick Start Guide
HERO
H
FPGA
CPU
P
1
3
For any technical questions, please e-mail us at
w ww . t e r as ic . co m .c n
2
4
support@terasic.com
For more information, please visit:
http://hero.terasic.com
USB Blaster Connector
USB 3.0 Device Port
Ethernet Port
USB 3.0 Host Port
HDMI 2.0a Port
Power Button
Ethernet Port
USB 3.0 Port
USB 3.1 Type-C Port
HERO Device
1
12V DC Power Supply
2
AC Power Cord
3
4
Micro USB Cable
Advertisement
Table of Contents
Summary of Contents for Terasic HERO
- Page 1 USB 3.0 Host Port HDMI 2.0a Port Power Button Ethernet Port USB 3.0 Port USB 3.1 Type-C Port HERO Device 12V DC Power Supply AC Power Cord Micro USB Cable For any technical questions, please e-mail us at support@terasic.com w ww . t e r as ic . co m .c n...
- Page 2 (Username: robot Password: intel123) Perform FPGA OpenCL DDR4 read and write tests: Open Linux Terminal Execute "cd ~/data" Execute "source altera_rte.sh" Execute "aocl diagnose all" Observe the DDR4 test results, as shown on the left For more information please visit: http://hero.terasic.com CPT-3346-00...
Need help?
Do you have a question about the HERO and is the answer not in the manual?
Questions and answers