Related Manuals for Ingersol Rand G2E
Summary of Contents for Ingersol Rand G2E
- Page 1 04581245 Edition 2 May 2014 Air Grinder, Die Grinder and Sander Series G2 (Angle) Maintenance Information Save These Instructions...
- Page 2 Nut. new needle bearing on hand for installation. Needle bearings are For G2E models, using the Clamp Nut Wrench (95), loosen the Clamp Nut (50) and pull the Angle Housing Assembly (48) away always damaged during the removal process.
- Page 3 Arbor Coupling (39 or 57) and Clamp Sleeve (40 or 58). from the hub of the Rotor. For G2E models, using snap ring pliers, remove the Coupling If the Rear Rotor Bearing (25) must be replaced, use snap ring Retaining Ring (42) from the Spindle Bearing Nut (41) in the large pliers to remove the Rear Rotor Bearing Retainer (24).
- Page 4 Using needle nose pliers, grasp Throttle Pin above O-Ring and insert into threaded end of Cylinder. Align Pin with holes in For G2E Models, if the Rear Spindle Bearing (44) was replaced, Cylinder and Housing and insert. Release Throttle Pin and push it proceed as follows: the rest of the way into the hole.
- Page 5 20.3 Nm) torque. The Bearing Cap has a lefthand thread: turn b. Press a new Upper Arbor Bearing into the bore. counterclockwise to install. For G2E models, using the Arbor Bearing Cap Wrench (92), install the Arbor Bearing Cap and...
- Page 6 Flange (84), wheel, Flange Nut (85). Install the Wheel Retaining Arbor and install the Flange Nut (85). Screw Washer (88) in the recess in the Wheel Flange and install the Assembly Instructions for Ergo Handle Wheel Retaining Screw (87) in the end of the Arbor and tighten Thread the Ergo Handle (75A) into the Angle Housing (67).
- Page 7 Trouble Probable Cause Solution Exhausts at wrong direction Incorrect orientation of the Flow Guide. Reverse the Flow Guide inside the Motor Housing. Front Rotor Bearing runs hot Incorrect installation of the Front Seal Reposition the Front Seal Cup Assembly flush Cup Assembly.
- Page 8 ingersollrandproducts.com © 2014 Ingersoll Rand...
Need help?
Do you have a question about the G2E and is the answer not in the manual?
Questions and answers