Summary of Contents for Colorado Video 619D
- Page 1 Model 619D video dual cross hair generator s/n_______________ september 2005...
- Page 2 WARNING This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual, may cause interference to radio communications. It has been tested and found to comply with the limits for a class A computing device pursuant to subpart of J of part 15 of FCC Rules, which are designed to provide reasonable protection against such interference when operated in a commercial environment.
-
Page 3: Table Of Contents
TABLE OF CONTENTS Section I GENERAL DESCRIPTION Page Introduction Purpose of Equipment 1.3 . Description of Equipment .Specifications Section II OPERATING INSTRUCTIONS 2.1. Introduction 2.2 . Installation and Operation 2.3 . Operation... -
Page 4: Introduction
Colorado Video Model 619D Dual Cross Hair Generator. PURPOSE OF EQUIPMENT The Model 619D Video Dual Cross Hair generator is used to overrlay lines on a television picturre. It allows rapid alignment of subject material with a predetermined location when used in conjunction with a standard TV camera and monitor. -
Page 5: Specifications
SPECIFICATIONS Size: 3.25” X 4.38” X 1.5” excluding controls and connectors Mounting: Free standing Construction: Solid-state, PC Board Power: +5 VDC Regulated, 1.2Watts Input Signal: Video, composite, 1 V p-p, Hi-Z, loop-through Video, composite, 1 V p-p, 75Ω Ω Ω Ω Output Signal: Operating controls:... -
Page 6: Operating Instructions
Connect a camera or other source of a composite video signal to a VIDEO IN connector on the rear of the 619D. Either terminate (75 ohms) or connect the remaining input connector to an additional destination. Connect a video monitor to the VIDEO OUT connector. - Page 7 This warranty is expressly in lieu of all other warranties and representation, express or implied, and of all other obligations or liabilities on the part of Colorado Video, Incorporated. In no event shall Colorado Video, Incorporated be liable for damages of any kind connected with the use of its equipment or its failure to function properly.