SALSA Warbird Cabling Manual

SALSA Warbird Cabling Manual

Cable routing instructions

Advertisement

RETAILER: This framesheet supplement MUST BE provided to the
end user.
At Salsa, we believe that a sense of adventure makes life better.
The bicycle can be so much more than just a bike; it's a path
to new places, new people, and amazing experiences.
Salsa. Adventure by bike.
®
Thank you for purchasing a Salsa Warbird! We want to give you
important information about your bike...
WARNING: Cycling can be dangerous. bicycle products
should be installed and serviced by a professional mechanic.
Never modify your bicycle or accessories. Read and follow all
product instructions and warnings including information on the
manufacturer's website. Inspect your bicycle before every ride.
Always wear a helmet.
Tools
2 mm hex wrench
Torque wrench that measures in Nm
Installation for Mechanical (Cable Operated)
Shifters & Disc Brakes
Warbird frames use cable routing tunnels for easy installation
and maintenance. Improperly routed cables will make themselves
obvious when it comes time to connect cables to components,
but follow these instructions to expedite the build process.
1. Remove the bottom bracket cover via the two M3 bolt heads.
2. If your bike uses a front derailleur, feed the shift housing
through the top DRIVESIDE port at the top of the downtube
until it comes to the opening in the bottom bracket shell.
Turn the housing up into the internal housing stop behind the
bottom bracket and feed the shift cable through the stop to the
front derailleur (Figs. 1 & 2).
Rear Shift Housing
& Electronic Wire
Rear Brake Line
Figure 1
25773 1/18
WARBIRD CABLE ROUTING INSTRUCTIONS
Front Shift Housing
& Electronic Wire
For additional product and safety information go to salsacycles.com/safety
Figure 2 Shown with BB cover removed
3. Insert the housing for the rear derailleur through the top
NON-DRIVESIDE port at the top of the downtube until it comes
to the opening in the bottom bracket shell, direct the housing
into the drive side chainstay tube and push it until it exits at the
rear of the driveside seatstay (Figs. 1, 2, & 3).
Rear Brake Line
Rear Shift Housing
& Electronic Wire
Figure 3
4. For brakes, feed the brake housing through the
NON-DRIVESIDE port on the side of the downtube until
it exits the rear non-driveside chainstay (Figs. 1 & 3).
5. Reinstall the M3 bottom bracket shell cover bolts and tighten
to 1 Nm.
Front Mechanical
Shift Housing
Rear Mechanical
Shift Housing
Front Electronic
Shift Wire
Front Mechanical
Shift Cable
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Warbird and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for SALSA Warbird

  • Page 1 The bicycle can be so much more than just a bike; it’s a path to new places, new people, and amazing experiences. Salsa. Adventure by bike. ® Front Mechanical Thank you for purchasing a Salsa Warbird! We want to give you Shift Housing important information about your bike... Rear Mechanical Shift Housing WARNING: Cycling can be dangerous.
  • Page 2 SERIAL NUMBER:______________________________ 5. Wiring for the REAR DERAILLEUR will come from the junction Get a pen and write down the serial number of your Salsa box in the bottom bracket shell through the tunnel that exits at immediately. The number is stamped into the bottom of the the back of the driveside seatstay (Figs.

Table of Contents