Introduction
This sheet supplies instructions to mount the Product
into a standard 19-inch equipment rack. The Rack-
Mount Slide Kit (the kit) contains all of the
components necessary.
WWarning
To prevent possible injury, do not restrict
access to the Product power cord, which is
the mains disconnecting device. If access
to the mains power cord is inhibited by
rack mounting, a properly-rated accessible
proximate mains disconnecting switch
must be provided as part of the
installation.
Note
Review the mounting instructions provided by
the manufacturer of the equipment rack before
you proceed with the installation.
Install Slides on the Product
Install the slides on the Product before you install the
Product into the rack. The numbers in Figure 1 show
the listed process steps.
Note
Do not remove the top or bottom cover to rack-
mount the Product.
4811274
June 2016 Rev. 1, 11/18
PN
To install the slides:
1. Push a flat-blade screwdriver between the
chassis and the plastic strip to remove the plastic
side-trim from the Product. Pry outward until the
strip is free of the two grooves, and then pull the
strip free from the Product.
2. Attach each rack-mount ear to the front of the
Product:
a. Remove the top and bottom hex screws from
b. Position each ear so that the holes in its tabs
c. Use two M4 x 16mm or two 8-32 x ½ inch
3. Use the two 8-32 x ¼ inch truss-head screws to
secure each of the two rack-mount filler bars to
the Product.
4. Attach a slide bar to both sides of the Product.
Secure each with three 8-32 x ¼ inch truss-head
screws.
5. Remove the four plastic molded feet from the
bottom of the Product:
a) Use a flat-blade screwdriver to push the tab in
b) Store the feet for future use.
©2016-2018 Fluke Corporation. All rights reserved.
Rack-Mount Kit
Note
So that the bezel is not
detached, complete one side
before you start on the other
side.
the side of each front handle.
align with the screw holes on a front handle.
pan-head screws to attach each ear to the
Product. See Figure 2 for screw identification.
the recess of each foot and pull the foot from
the cover.
Y9600
Instructions
1