EADS Socata TB 20 Pilot's Information Manual page 832

SUPPLEMENT 50
"SHADIN"
MICROFLO-LTM
DIGITAL
FUEL MANAGEMENT
SYSTEM
SECTION 7
DESCRIPTION
SOCATA
The digital fuel management system indicator is installed at the lower part of
the R.H. instrument panel. It helps the pilot to manage fuel during the flight.
The fuel flow is continuously displayed on L.H. side aftha screen.
All data selected by the pilot ("Fuel to dest.", "Endurance",
~Nm
Gal", "F. at
dest.", etc ... ) are displayed on R.H. side of the screen.
7.1 - Fuel tanks full
Move the "ADD/FULL" toggle switch to the FULL position and hold.
Press the "ENTER{TEST" button.
Release the "ADD/FULL" toggle switch so it returns to the center position.
To verify, move the "USED/REMH toggle switch to the REM position. Total
usable fuel will be displayed.
7.2 - Partial fuel added
Add the amount of fuel from the refueling meter to the amount of fuel
remaining. Enter the total using the following steps:
1 - Move "USED/REM" toggle switch to REM position and hold.
2 - Press and hold "ENTER{TEST" button to increment fuel remaining until
figure to be entered is reached; then release button.
3 - Release the "USED/REM" toggle switch. The displayed figure is
entered into memory as fuel remaining on the board.
4 - If the required figure is exceeded, follow the procedure in this
Supplement, chapter 7.3 "Correcting fuel on board entry error".
9.50.6
May 15, 2001