Advertisement
WARNING:
If used in a bathroom Mango Mirror must be plugged into a Ground-Fault Circuit-Interrupters
(GFCI) outlet.
Mango Mirror should not be used in an environment with consistent high humidity.
RISK OF ELECTRIC SHOCK. DRY LOCATION USE ONLY.
Failure to follow this warning could result in serious injury and electrocution from electrical shock.
General Installation Instructions
Model: MM1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Mango Mirror MM1
- Page 1 General Installation Instructions Model: MM1 WARNING: If used in a bathroom Mango Mirror must be plugged into a Ground-Fault Circuit-Interrupters (GFCI) outlet. Mango Mirror should not be used in an environment with consistent high humidity. RISK OF ELECTRIC SHOCK. DRY LOCATION USE ONLY.
- Page 2 General Installation Instructions Model: MM1 Package Contents: (1) Mango Mirror (Glass mirror with attached metal frame and power chord) Wall mounting Hardware pouch containing: (1) Wall -Hook (2) Drywall Anchors (2) Screws (1) General Installation Instruction document Preparation Tools required for assembly: (Not Included) • Pencil • Screwdriver • Level • Tape measure • Safety glasses Important: When choosing your location, please ensure that the power adaptor cable will reach your power outlet when installed.
- Page 3 General Installation Instructions Model: MM1 Installation Steps: 1. Once the location and height of the mirror has been determined, place the wall-hook on the wall as shown below. Position it over wall studs when possible for the most secure installation. Use a level (not included) to ensure the wall-hook is level. Mark the position for the screws holes with a pencil through the center of the two holes. Wall Wall-hook Wall-hook Front view Side view 2. Put aside wall-hook. If no studs are found on marked positions, use the screwdriver to install self-drilling drywall anchors on all marked positions. For your safety please ensure that anchors are installed correctly. If damaged, please replace with appropriate wall anchors rated for at least 50 lbs, before continuing. 3. Place the wall-hook against the wall; line up the holes against the anchors against the wall. Insert the screws into the wall-hook holes and the wall anchors (or directly into wall studs if applicable) and then tighten firmly with a screwdriver. For your safety please ensure that the wall-hook is firmly secured and tightened against the wall.
- Page 4 General Installation Instructions Model: MM1 4. Mirror is heavy; two people should carry the mirror. Based on your power outlet placement, decide on which side to hold the power plug as you carry the mirror. Ensure that the motion sensor ring is to the bottom right facing out towards you. Then place the mirror back metal brace against the wall and lift it up so that the wall-hook is inserted in the slot in the back metal brace. The back metal brace must be flush against the wall. Then gently lower the mirror so that the metal brace slot top sits into the wall hook, holding the mirror in place. Once complete. Check to confirm that the mirror is correctly and completely flush against the wall, is hanging on the wall-hook and being held securely in place, before letting go of the mirror. 5. Plug the power adaptor into the power outlet and follow the instructions on the mirror display and use your mobile app as instructed, to setup Mango Mirror. Wall-Hook Slot for Wall-Hook Back Metal Brace Motion sensor Thank you for choosing Mango Mirror!
Need help?
Do you have a question about the MM1 and is the answer not in the manual?
Questions and answers