Advertisement
Available languages
Available languages
outlet. This is a dangerous practice since it provides no effective grounding for the beverager cooler and may result in shock
hazard.
Installation Limitations
• Do not install your beverage cooler in any location not properly insulated or heated (e.g., garage etc.). Your beverage
cooler was not designed to operate in ambient temperaturew settings below 55° Fahrenheit.
• Select a suitable location for the beverage cooler on a hard even surface away from direct sunlight or heat source (e.g.,
radiators, baseboard heaters, cooking appliances, etc.). Any floor unevenness should be corrected with the leveling legs
located on the front and rear bottom corners of the beverage cooler.
Note: Your beverage cooler is designed for freestanding installation only. It is not designed for built-in application. This unit is for
indoor use only.
Use of Extension Cords
• Avoid the use of an extension cord because of potential safety hazards under certain conditions. If it is necessary to use
an extension cord, use only a 3-wire extension cord that has a 3-blade grounding plug and a 3-slot outlet that will accept
the plug. The marked rating of the extension cord must be equal to or greater than the electrical rating of the appliance.
Shelving
To remove or replace a full-width slide-out shelf:
1. Gently tilt the shelf up and slide forward until the shelf has been completely removed.
2. To replace the shelf, gently slide the shelf back.
Normal Operating Sounds You May Hear
• Boiling water, gurgling sounds or slight vibrations that are the result of the refrigerant circulating through the cooling coils.
• Compressor makes operational sounds when cycling on and off.
6
Advertisement
