CSL ACROBAT Installation Manual

I N S TA LL ATI O N G U I D E
READ AND FOLLOW ALL SAFETY INSTRUCTION! SAVE THESE INSTRUCTIONS AND DELIVER TO OWNER AFTER INSTALLATION.
WARNING: RISK OF ELECTRIC SHOCK
Before installation, servicing, or peforming routine
maintenace disconnect power by turning o the circuit
breakers both to the outlet box and to its associated
wall switch
Installation and service of luminaires should be
performed by a qualified licensed electrician in
accordance with all local and National Electical Codes
DO NOT install damaged product
Verify that supply voltage is correct by comparing it
with the luminaire label information
All wiring connections should be capped with UL
approved recognized wire connectors
STEP 1 - FRAME INSTALL / HORIZONTAL ADJUSTMENT
SPREAD HANGER BARS TO APPROPRIATE DISTANCE. FASTEN WITH HARDWARE (BY OTHERS) TO PREVENT VERTICAL MOVEMENT OF FIXTURE.
WARNING: RISK OF INJURY
Allow luminaire to cool before servicing and
performing maintenace
Follow all manufacturer's warnings and restrictions
for: driver type, mounting locations, replacement and
recycling
Wear safety glasses and gloves when installing,
maintaining or servicing
Avoid direct eye exposure to the light source while it
is on
ROUND (DOWNLIGHT) SHOWN.
T-BAR FOLLOW SAME STEPS FOR SQUARE
1 AND 2 INCH IC/CHICAGO RATED HOUSING |
WARNING: RISK OF FIRE
Keep combustible material away from luminaire
Do not install insulation within 3" (76mm) of any part
of the luminaire or in a way that may entrap heat
WARNING: RISK OF PRODUCT DAMAGE
Never connect components under load
Do not touch the yellow surface of the LED as it may
damage the light engine
5
1 INCH:
2 in (67mm)
8
3
2 INCH:
3 in (85mm)
8
3 INCH: 3
4 in (112mm)
8
3
4 INCH:
5 in (138mm)
8
WOOD
A C R O B A T
1 INCH: 5 5
2 x 2 in
8 8
(67 x 67mm)
3 3
2 INCH:
3 x 3 in
8 8
(85 x 85mm)
3 3
3 INCH:
4 x 4 in
8 8
(112 x 112mm)
3 3
4 INCH: 5 x 5 in
8 8
(138 x 138mm)