Advertisement
6. Edit the Active Preset (default decoder settings) by using the down arrow and select to
enter values for the Downink Frequency, Symbol Rate, Network ID, Polarization and
Input as listed above. (Use the down arrow key to move through the available menus
until the desired option is displayed).
7. Set the RF setting parameters below:
a. 5.15 for L01
b. 0.0 for L02
c. 0.0 for Xover
d. Select RF#1
e. Select Galaxy 13
8. If you are not using the receiver to power the LNB, confirm that Power is set to Off and
L0 Select is set to L01. Press the down arrow to go to the next menu.
Note that if you require LNB Power for the RF signal input, set Power to either 13, 18,
or Polariser. Refer to the Presets Menu section of the user manual received with the
unit.
9. At this time, you should get a (signal) Lock. (Check RF, if not).
10. Press Menu, the message
11. If successful, the message
to accept the changes. You should now get video on the monitors.
Note: you may have to arrow up or down here to receive the TV Japan signal.
12. If you see the message
212-713-8344 and provide them with your User Address for authorization. To find your
Decoder Address, from the Main Menu, move the cursor to the About menu item and
press Select.
13. If you intend to use the ASI output you will have to turn it on (default is off).
This procedure is covered on page 26 of the manual (quick setup follows).
14. Press Menu to move from the initial display into the Main Menu system.
15. Press the right arrow key so the cursor is to the left of the Setup menu item. Press the
Select button to display the
Acquiring Network Information
Network Acquired, Save Changes?
Not Authorized,
please contact Japan Network Group, Inc. at
Setup
menu.
should display.
Displays. Select Continue
Advertisement
