Table of Contents
Advertisement
Advertisement
Table of Contents
Summary of Contents for jobmate 234815
- Page 1 16L KNAPSACK SPRAYER SKU: 234815 INSTRUCTION MANUAL...
-
Page 2: Table Of Contents
INDEX Attention ........................... 1 Introduction and Special Safety Directions ................2 Introduction ........................2 Safety Instructions ......................2 Main Components ........................2 Assembley Instructions ......................3 Fitting the Fiberglass Wand ................... 3 Fitting the Multiple Sprayer Jet Adaptors ..............4 Check the Support Strap is Attached ................ -
Page 3: Attention
1. Attention O-rings are needed to make the sprayer function correctly and they reduce leaks, please check all O-rings are in place before use. -
Page 4: Introduction And Special Safety Directions
2. Introduction and Special Safety Directions 2.1 Introduction To get the most out of your new backpack sprayer, please read through these instructions before use. There are handy tips in here for maintenance and safety. Please keep them on hand for future reference. -
Page 5: Assembley Instructions
4. Assembley Instructions 4.1 Fitting the Fiberglass Wand Please insert the fiberglass pole into the trigger mouth and screw down to secure. -
Page 6: Fitting The Multiple Sprayer Jet Adaptors
4.2 Fitting the Multiple Sprayer Jet Adaptors The fiberglass pole for the wand will already have simple point spray attached to it. For other options, please unscrew and reattached as required. Please check that washers are always in place to prevent unwanted leakage. -
Page 7: Check The Support Strap Is Attached
4.3 Check the Support Strap is Attached Before you start using this sprayer, you need to check that the support strap is attached to the left underside of the sprayer. There is a simple clip system which is shown in the image below. 5. -
Page 8: Problem Solving
5.2 Problem Solving Problem Solution Leakage and liquid blockage Inspect the rubber washer at every seal and connection part, then replace or screw tighter if they are broken or loose. Clean thoroughly after usage. Feeling too much pressure Clean the filter net and the spray head if they are when shaking the operation blocked up add some lubricant Clean thoroughly after usage. -
Page 9: Spare Parts
7. Spare Parts SKU234815 Spare parts Name Quantity Location Adjustable spray head In the tank Y-type spray head In the tank Single spray head In the tank 3-way spray head In the tank Switch splitter In the tank Fix Clip In the tank Leather Bowl In the tank...