Download Print this page

Air Innovation Wine Guardian Ducted Wine Cellar Cooling System Quick Start Installation Manual

Advertisement

Quick Links

For more information about your Wine Guardian
Ducted Wine Cellar Cooling System
, visit www.wineguardian.com/distributors
or call +1 315 452 7400.
Wine Guardian
®
is a registered trademark
of Air Innovations
®
A Division of
Air Innovations®
Rev. 07/12
Wine Guardian
Ducted Wine Cellar Cooling System
"Quick Start" Installation Guide
This document is a pictorial guide on installing the Wine Guardian Ducted Wine Cellar Cooling System. It is not
intended to replace the detailed instructions found in the WG Ducted Installation, Operation and Maintenance
(IOM) manual, which includes important safety messages all WG installers and owners should carefully follow
for safe and optimal performance of the system. A copy of the manual may be viewed and downloaded at
www.wineguardian.com/customer service.
Refer to the IOM manual for installation instructions related to duct collars and duct collar kits, optional remote
interface control and remote sensors.
If you have any additional questions related to the installation, operation or maintenance of your WG system,
please contact your authorized WG distributor or WG service department.
®

Advertisement

loading
Need help?

Need help?

Do you have a question about the Wine Guardian Ducted Wine Cellar Cooling System and is the answer not in the manual?

Questions and answers

Summary of Contents for Air Innovation Wine Guardian Ducted Wine Cellar Cooling System

  • Page 1 Ducted Wine Cellar Cooling System “Quick Start” Installation Guide This document is a pictorial guide on installing the Wine Guardian Ducted Wine Cellar Cooling System. It is not intended to replace the detailed instructions found in the WG Ducted Installation, Operation and Maintenance (IOM) manual, which includes important safety messages all WG installers and owners should carefully follow for safe and optimal performance of the system.
  • Page 2 3. Wiring Thermostat (Continued) . Water-Cooled Versions Only 1. Pre-Install Start Up A. Remove unit from box. Check for any signs of F. Provide 1¼” (32 mm) diameter hole within wall or racking A. Connect cooling water inlet and outlet concealed damage, and that all optional equipment pipes to cooling water source.