Reef Brite XHO-K15 Quick Manual

Led add-on kit

Important please read all instructions carefully before installing your

XHO-K15 LED ADD-ON KIT:

The complete ADD-ON KITS weight approximately 2 lbs. Reef Brite has

gone through great care to ensure that the XHO-K30 LED ADD-ON KIT

installs seamlessly to your fixture. Due to various tank sizes/glass

thicknesses and older style mounts offered, before installing it is very

important that you check your tank manufacturers specs as well as

checking the mount you are using to ensure that it is compatible and can

support the additional weight. Reef Brite will not be responsible for

improperly installed kits or any damages that may result.

If you have any questions before or during the installation of your kit, please contact

joy@reefbrite.com and one of our customer service representatives will be glad to assist

you. For faster service please provide your phone number and a good time to call. Thank

you

Installation instructions for RMS mounts:

When working near or around your aquarium make sure all working surfaces are

completely dry before handling any electrical equipment.

Make sure your fixture is unplugged from electrical outlet and

disconnected from the power supply before attempting to install the XHO-

K15 kit.

If fixture was in use even for just a short period let cool. LED's can get very hot

during operation and can cause personal injury or damage surfaces if

proper care in handling is not taken.

Once cool, place fixture on a secure table or work surface.

Locate the four M5 x 12mm mounting screws included with your XHO-K15 kit. These

screws are required to install the XHO-K15 kit.

Do not attempt to use hardware not supplied with your XHO-K15 kit as

damage to your fixture could result.

Attach the two brackets that came with your XHO-K15 kit by placing them under the

RMS mount on your XR series light so that the holes align with RMS mount and the

threaded holes on your fixture.

Using the provided hardware attach the brackets and mount to fixture. It is

recommended to use care when threading the screws and avoid

overtightening the screws once installed.

Table of Contents

Do you have a question about the XHO-K15 and is the answer not in the manual?

Page 1 Do not attempt to use hardware not supplied with your XHO-K15 kit as damage to your fixture could result. Attach the two brackets that came with your XHO-K15 kit by placing them under the RMS mount on your XR series light so that the holes align with RMS mount and the threaded holes on your fixture.
Page 2 Locate the hardware that came with your hanging kit. Attach the two brackets that came with your XHO-K15 kit by placing them over the top of the fixture, so that the holes in the XHO-K15 brackets align with the threaded holes on your fixture.
Page 3 XHO's. Using the supplied 2-way connector plug in each of the two XHO's. Attach the supplied power supply in your XHO-K15 kit to 2-way connector. When plugging in the 2-way connector to the XHO's or power supply to the 2-way connector, make sure to insert plugs until you feel them lock in place.