Summary of Contents for logika Smart Translator WL-ZWWWDPW-0101-01
- Page 1 Smart Translator WL-ZWWWDPW-0101-01 Product Manual Version 1.0 © 2019 Logika Limited...
- Page 2 Introduction Thank you for choosing Logika. Please take a moment to carefully read through the manual to ensure safe and proper installation and use. • Before use, the product must be properly installed as described in this manual by a qualified technician.
-
Page 3: Device Layout
Device Layout Terminal Blocks Output 1 Output 2 System Indicator Multi-Function Button Power DC 12V Ground Wire... -
Page 4: Specifications
Features • Communication Mode: IEEE 802.15.4 Zigbee. Space saving. • • Easy to use. Support time setting and linkage control to other smart devices. • Specifications Communication Protocol IEEE 802.15.4 Communication Distance 100m Port Output Configuration Double-switched relay output signal Working Temperature -10°C to +55°C Power... -
Page 5: Installation Steps
Installation Steps Hardware Installation 1) Connect the device to a DC 12v power source, as shown below. Ground DC 12V 2) Press and hold the terminal block to open the connector and connect the output cable to the corresponding terminal. Release to lock the cable in place. Note that the output load capacity is <... - Page 6 Adding the Device to the Smart Home Network Use the Logika Smart Home app to add the device to the Smart Home system. Please refer to the Logika Smart Mobile App user guide which will take you through the process of adding smart devices to the system.
-
Page 7: Device Functions
Device Functions When the device is first powered on, it will normally automatically attempt to connect to the Zigbee Smart Home network. The System Indicator light will flash as it’s searching for the network. If it connects, the light will remain on for 2 seconds and then go out. If this does not happen, you can manually connect via the mobile app and follow the instructions below. -
Page 8: Troubleshooting
You should now be free to add the device to the local smart network. The issue you are experiencing is not mentioned here. Please contact us at support@logika.nz with your issue and we will do our utmost to help!