After Installation - Moen Flo Smart Water Shutof Manual

Installation
DO NOT install the Smart Water Shutoff on fire sprinkler or suppression systems or hot water distribution lines.
DO NOT install the Smart Water Shutoff underground.
18
STEP 1
Locate and turn off the main
water supply valve
STEP 2
Relieve water pressure by opening
as many fixtures as possible
STEP 3
Install the Smart Water Shutoff on the main water line after the
manual shutoff and the pressure reducing valve (if applicable)
A.
Do not solder fittings with the Smart Water Shutoff on the
line. Doing so risks damage to the Smar Water Shutoff
B. Use the Installation Spacer if needed
C. Position the Smart Water Shutoff with the arrow pointing
in the direction of the flow of water into the home (Shutoff
can be installed in either a horizontal or vertical position)
D. On well systems, install the Smart Water Shutoff after the
well pressure tank with 100 mesh or finer wye strainer

After Installation

STEP 4
Slowly turn on the main water
supply and look for any possible
tion
leaks around the point of installa
STEP 6
Connect the power adapter
If there is no outlet nearby you may have to drill
through the home's exterior wall to an interior outlet.
Verify that there are no pipes or obstructions behind
the wall before drilling. (You may also wish to pur-
chase a power extension cord)
Note: For outdoor installations, a weatherproof
receptacle enclosure MUST be used.
STEP 5
Turn off the fixtures opened from
Step 2 and check for any possible
leaks in the installation
STEP 7
Verify LED status
A. Valve LED is solid green when valve is open; solid
red when closed
B. Status LED is green when connected to the home's
WLAN; Status LED is blinking green when connected
to the home's WLAN but there is no internet connec-
tion; Status LED is solid white when there is no con-
nection to the home's WLAN or internet connection
19