Fitting Air Filter Unit
The air compressor comes originally packed without the air filter unit fitted
Procedure:
1.
Remove the temporary protective red plug from the air inlet port.
2.
Screw in the air filter unit & hand tighten. Do not use Teflon tape or
lubricants on the thread.
3.
Unscrew the top lid to check if the element is correctly in place.
Important Safety Instructions
•
Do not disassemble. Do not attempt repairs or modifications. Your warranty
will be void if this instruction is ignored.
•
Do not use this product in an area where it can fall or be pulled into water or
other liquids.
•
The base tray is fitted to place a barrier between the compressor & sandy or
dusty ground, plus provide a stable operating platform, therefore keep the
tray clean at all times during use.
•
Use this compressor with 12Volt DC power only.
•
This product should never be left unattended during use.
|Black Max Compressor
Page 7