Page 1
ASSEMBLY and INSTALLATION INSTRUCTIONS N° Description Main Bow Sides Eclipse Contents Main Bow Stays Main Bow Joiner Rear End Bow Sides Front End Bow Sides End Bow Joiners End Bow Stays Top Attachment Bars Bag A (Bow Knuckles) 10 Bag B (General Hard-...
ASSEMBLY and INSTALLATION continued... FRAME ASSEMBLY: 1. Locate all of the Frame components (Part N° 1,2 ) Figure 1 2. From bag A containing the black plastic parts remove the four joining knuckles. Using the 8G x 1/2” pan- Figure 1 Frame components. head, screw the joining knuckle marked “A”...
Page 3
ASSEMBLY and INSTALLATION continued... 8. Take the 4 bent end bow sides (Part N°4 & 5) and place them in pairs with the plastic insert Figure 7 facing downwards. Now screw on the bow knuckles making sure that the nut recesses are facing outwards. Figure 8 9.
Page 4
ASSEMBLY and INSTALLATION continued... End Bow Holes 12. With the holes lined the same as Figure 13 you can now slide the end bow joiners and the main bow joiner (Part N°3) onto the Main Bow Holes two frame assemblies. Note: The center joiner must be sitting on top of the fabric Figure 14 End Bow Holes...
Page 5
A, and lubricate bolt A to avoid binding bolt to nut. Figure 22 Canopy Position 22. Now you can fit the Eclipse Canopy to the deck mounts. The Kingfisher logo on the canopy should be at the back of the boat.
Page 6
ASSEMBLY and INSTALLATION continued... 24. Make sure that the fabric is pulled over all corners of the end bows. Figure 23 25. Open the canopy by releasing the four cam leavers at the bottom of the legs and pulling out the two end bows. Figure 23 End Bow Knuckles 26.
Page 7
ASSEMBLY and INSTALLATION continued... Travel Sock Strap Instructions 32. Find the bunji cord with the two hooks attached. Figure 32 33. Fit the travel sock to the canopy and fold it down flat to the boat. 34. Clip one end of the cord to the sup- plied loop on the canopy cover.