Q-Optics Radiant Instructions & Care

Lighted instrument
Hide thumbs Also See for Radiant:

Advertisement

CLEANING & CARE
I N S T R U M E N T AT TA C H M E N T
& B AT T E RY PA C K
The instrument attachment and
battery pack can be cleaned
using Q-Optics optical cleaner
or moistened cloth. To remove
debris on instrument attachment
or battery pack, spray the
Q-Optics Cleaner directly onto
the surface. Using a microfi ber
cloth or clean cloth, thoroughly
wipe down the instrument
attachment (including the cable)
and battery pack.
DO NOT spray the cleaner
directly into any electrical
openings. Doing so could cause
damage to the unit and void
product warranty.

DISINFECTION

The instrument attachment
and battery pack should
only be disinfected using the
Q-Optics Dis-Foam™. Any
other form of disinfectant
could cause damage to unit.
To disinfect, simply spray
the Q-Optics Dis-Foam™
directly onto the surface to be
disinfected. Using a microfi ber
cloth or clean dry cloth,
thoroughly wipe units dry.
DO NOT spray the foam
directly into any electrical
openings. Doing so could
cause damage to the unit and
void product warranty.
P.O. Box 382120
Duncanville, Texas 75138-2120 USA
Phone: (972) 298-2669 • Fax: (972) 298-6592
1-800-858-2121
email: support@q-optics.com
www.q-optics.com
UI-317-10010-01 ECN # 729
Radiant
Lighted
Instrument
Instrument
Attachment
Instructions
& Care

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Radiant and is the answer not in the manual?

Questions and answers

Summary of Contents for Q-Optics Radiant

  • Page 1 Instrument Instrument Attachment The instrument attachment and battery pack can be cleaned using Q-Optics optical cleaner or moistened cloth. To remove debris on instrument attachment or battery pack, spray the Q-Optics Cleaner directly onto the surface. Using a microfi ber...
  • Page 2 Collar between Thumb and fore fi nger battery pack and as shown. enjoy your Q-Optics Radiant™ Light System. Use circular motion The fi ber optic light transmitting surfaces on both ends of the fi ber optic clip or wand should be wiped clean with isopropyl alcohol before autoclaving or chemiclaving.

Table of Contents