Advertisement
KEMKRAFT
* INSTALLATION INSTRUCTIONS *
1. The KEI-850 Display box should be permanently installed in a location that is best for the
application. It is usually mounted straight out the drivers side window on a pedestal stand.
2. When the box is installed, place a vehicle in the alignment machine and install the
mechanical fixture onto the steering wheel. Ensure that the KEI-850 display box can be
easily viewed while loading an Unfixtured Clear Vision Tool onto a steering wheel.
* OPERATING INSTRUCTIONS *
NOTE: As always, these Steering Wheel Gauges are delicate, accurate, gauging tools
that need to be treated as such and therefore must be installed in a holder when
not in use. If these tools do not have a holder & are thrown down on a table
during use, the warranty will be void.
1. Apply power to the KEI-850 by turning on the power switch located on the bottom left part
of the enclosure. This power switch also doubles as a circuit breaker for the KEI-850
Display box. Should the breaker ever trip the power switch only needs to be turned to the
off position and back on to reset the breaker.
2. After the power has been applied to the KEI-850 Display box the LCD display will have this
display.
4. If power is applied and the KEI-850 Display box has the LCD has the following display, the
calibration data is bad and the unit needs to be calibrated.
* WARRANTY AND SERVICE INSTRUCTIONS *
Kemkraft Engineering, Inc. warranties this equipment against defects in workmanship and
materials for a period of 90 days from date of shipment. We will, at our option, repair or
replace products which prove defective during the warranty period. No other warranty,
expressed or implied, is given. KEI is not liable for consequential damages. Damage caused
to the equipment as a result of improper use or abuse, or unauthorized modification of the
instrument is not covered under this warranty.
For service contact:
96-033.doc
47650 Clipper Dr. Plymouth Twp., MICHIGAN 48170 (734)-414-6500
MODEL KEI-850 READOUT BOX
XX.XX Deg TL#1
CAL SW = Calibrate
MEMORY ERROR
CALIBRT TOOL NOW
Kemkraft Engineering, Inc.
47650 Clipper Dr.
Plymouth Twp., Michigan 48170
2
ENGINEERING, INC.
734-414-6500
734-414-6599 fax
Advertisement
