GE Dimension 1000 Instructions page 2

IF MULTIWATT:
Multiwatt ballasts are available in various combinations
of wattage. See wiring instructions on wiring tag inside the
luminaire.
LAMP INSTALLATION
CAUTION
Risk of burn
• Allow lamp/fixture to cool before
handling
Use only lamps specified on nameplate. Observe
lamp manufacturer's recommendations and
restrictions on lamp operation, particularly ballast
type, burning position, etc.
Observe lamp manufacturer's handling instructions.
Lamps should be installed to NEMA-EEI specified tightness
of 35-inch lbs torque.
M O U N T I N G
CAUTION
Unit will fall if not installed properly
• Follow installation instructions
Figure 2
g
GE Lighting Solutions • 1-888-MY-GE-LED • www.gelightingsolutions.com
GE Lighting Solutions is a subsidiary of the General Electric Company. Evolve and other trademarks belong to GE Lighting Solutions. The GE brand and logo are trademarks of the General Electric Company.
© 2011 GE Lighting Solutions. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
Predrill pole as directed in Figure 2. Install the two (2)
studs into the nut plate (or nuts in the round pole adapter)
until the threads are fully engaged.
CAUTION: Ensure that nuts fully engage the two studs. Correct
tightening of stud nuts is important to ensure proper function of
mounting system. Torque to 18 - 22 foot pounds.
PHOTOELECTRIC CONTROL
If present, the receptacle should be oriented to true North
before the control is installed. Loosen the two (2) screws
holding the receptacle, rotate it until the arrow points North,
and retighten the two (2) screws.
MAINTENANCE AND CLEANING
The exterior of the door glass should be cleaned when
dirty with a warm solution of mild non-abrasive detergent
and water. Rinse with water and wipe dry. If required the
inside of the optical assembly may be cleaned in a similar
manner.
Aging lamps should be replaced based upon the Lamp
Manufacturer's recommendations and the lighting
requirements for the installation.
1 - 8 8 8 - 6 9 - 4 3 5 3 3 -
35-201578-Y2 (11/99)