ALTUS CPC-8 Installation Instructions

Tools required:

#2 Phillips Drive Screw driver or #2 Square bit drive
INSTALLATION WITH WORK SURFACE
AND CORD TRAY:
1
Arrange Power Cord within
Cord Tray (See Fig.A)
2 Fasten Power Cord from underneath
the worksurface by fastening cord
with cord clamp with 1/4-20 x 5/8" Long
Pan Head Phillips Drive
Machine Screw.
3 From underneath the worksurface,
align cord tray with pre-drilled holes
in worksurface.
Once aligned, fasten (4) #10 x 3/4" Long
Pan Head Phillips Drive screws into the
front (4) four locations (See Fig. B).
Finish attachment by placing
and attaching last two (2) #10-24 x 7/8"
Long Pan Head Phillips Drive Screws into
the back side of cord tray (See Fig. C)
4
Attach Cord Hook from underneath
the worksurface using (2) #10 x 3/4" Long
Pan Head Phillips Drive Recex Low Root
Screws (See Fig.E)
3731 Northridge Dr NW, Unit 1 | Walker, MI 49544 | T: 888.537.1311 | F:616.233.9549 | www.altus-inc.com

Parts Included:

(1) Power Cord
(1) Cord Hook Bracket
(2) #10 x 3/4" Long Pan Head Phillips Drive Recex Low Root Screws
(1) 1/4-20 x 5/8" Long Pan Head Phillips Drive Machine Screws
(1) Cord Clamp
Fig. B
CPC-8
Installation Instructions
INS-CPC8 (Rev.A)
Fig. E
Fig. A
Fig. C