Page 1
EUROC 4 INSTALLATION STEPS TO START UP THE EUROC 4 WATER SOFTENER 1. WATER CONNECTION Connect water to the unit, inlet and outlet. Connect also the drain line. Rear view...
Page 2
EUROC 4 INSTALLATION Top view 2. FILLING THE BRINE DEPOSIT WITH SALT The brine deposit should be fill up with salt. 3. START UP Fill with water half the bin. Wait around 15 minutes. If posible, wait 3 to 4 hours before starting the unit the first time.
Page 3
EUROC 4 INSTALLATION Press during 3 seconds to start a manual regeneration. Open the water supply very slow to approximately the ¼ open position. Let it flow until the air inside is purged from the tank. Allow the water to run to drain until the water runs clear from the drain line.