Advertisement
Quick Start Guide
The i-MO appliance is supplied fully configured and ready to use. This guide describes how
to connect and get started with the device.
1) Attach WiFi antennas (optional)
The i-MO appliance is supplied with a WiFi interface. This can be enabled on request at time
of order. If the WiFi interface is enabled install the two antennas on the aerial connectors
numbered 4 and 5 as shown below. Position these at an angle as shown below.
2) Attach 3G/4G antennas and cables
Up to 3 antennas may be provided dependent upon the number of modems installed. The
antennas must be mounted outside and as high as possible. The antennas should be spaced
at least 1 metre apart from each other.
The connector on each aerial cable should be attached to the aerial sockets (1-3) as shown
below. Note: Connectors should be touch tight only! Do not over tighten.
Electronic Media Services Ltd
Passfield Business Centre, Lynchborough Road, Liphook, Hampshire GU30 7SB
Tel: 01428 751655 Fax: 01428 751654 e-mail: imo@ems-uk.com
www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299
Advertisement
