Table of Contents
Advertisement
ous and all-pole cut off from the mains
(according to NIN SEV 1000).
Electrical connection:
1
2
3
N
TO ATTACH THE SEAL TO THE
RABBET
• Clean the rabbet in the work surface.
• Bond the seal stripe supplied on the up-
per surface of the rabbet along the edges
of the cut out section.
• Cut the seal stripe into four pieces in rela-
tion to the length of the edges of the rab-
bet.
• For the four corners of the rabbet the
ends of the seal stripes must be cut into
mitres. Do not bond the ends over one
another.
• Bond the seal stripe flush into the corner
of the rabbet. Make sure that no silicon
ASSEMBLY
400V 2L-1N ~
L1
1
L2
2
3
220V-240V
N
N
PE
• Do not extend the tapes.
TO ATTACH THE SEAL.
• Clean the worktop in the area of the cut
• Bond the seal stripe supplied on the low-
220V - 240V ~
1
2
3
N
compound can get below the glass ce-
ramic when grouting.
out section.
er edge of the appliance along the outer
edge of the glass ceramic. Do not extend
it. Let stay the cut ends in the middle of
one side. When, you cut it to length (add
some mm), push the two ends together.
min.
500mm
electrolux 13
L1
220V-240V
N
PE
min.
50mm
min.
2mm
Advertisement
Table of Contents
