Page 1
433,42 MHz www.stafer.com USER MANUAL: Sun/wind device for 1 motor 593.K.RS.00 ricycled paper versione 2.0...
Page 2
STAFER S.p.A. declines all responsibility for damage incurred due to weather events not detected by the device. Any other use beyond the field defined by STAFER S.p.A. is prohibited and involves, as well as the failure to comply with instructions provided in this guide, the cancellation of STAFER S.p.A.
Page 3
01. WARNINGS. PAY ATTENTION! Important safety instructions! 01.1 WARNING FOR SAFETY ü Incorrect installation can cause serious injuries. ü Keep these instructions for future maintenance work and disposal of the product. ü All the product installation, connection, programming and maintenance operations must be carried out only by a qualified and skilled technician, who must comply with laws, provisions, local regulations and the instructions given in this manual.
Page 4
02. ASSEMBLY INSTRUCTIONS 02.1 BUTTON AND LED DIAGRAM Components label: (1) Blades WIND (2) Sensor body (3) Connector for cable (4) Closing cover MANOEUVRE (5) Closing cover scew (6) Retaining cable (7) Adjusting and fixing screws (The screws must never be completely unscrewed) (8) Wall fixing (9) Wall support (10) Screws cover...
03. ELECTRICAL CONNECTION ü Make connections with power supply disconnected. ü Check that the power supply does not depend from electrical circuits for lighting. ü Always connect the motor to the grounding system (yellow/green). ü The supply line must be equipped with a circuit breaker. The supply line must be fitted with a device with a voltage category III, i.e. the distance between the contacts must be of 3,5 mm at least.
Page 6
05. HOW TO MEMORIZE THE FIRST HANDHELD TRANSMITTER Motor makes 2 upward movements Press P1 for some seconds until the 3 LEDs light on Give power to the device STOP Within 15 sec. press STOP of the transmitter you want Motor makes 1 brief upward to memorize.
Page 7
07. MEMORIZATION/DELETION OF A TRANSMITTER To memorize a transmitter, in addition to the onboard buttons (see section 05, "How to memorize the first handheld transmitter"), you can use the command buttons or, for added convenience, an already stored handheld transmitter. If the transmitter is already stored in the device, by performing the procedure the transmitter is deleted from the memory.
08. WIND SENSOR If the wind speed is above the set threshold for at least 3 seconds, an upward movement is commanded to protect the awning (wind alarm). During this phase all manual commands are disabled. The device exits from the “wind alarm” if the wind speed keeps below the set threshold for at least 8 minutes. The wind threshold is varying from 5 km/h to 35 km/h.
09. SUN FUNCTION If the intensity of the sun is above the set threshold for at least 2.5 minutes, an automatic downward manoeuvre is performed; if the intensity of the sun is below the set threshold for at least 18 minutes, an automatic upward manoeuvre is performed. Once an automatic downward manoeuvre for the presence of the sun is performed, the next automatic manoeuvre performed by the device will be an upward movement for absence of sun and so on.
Page 10
B.2 USING AN HAND-HELD TRANSMITTER Mod.593 USING AN HAND-HELD TRANSMITTER Mod.594 01. Select the correct radio channel and bring the motor 01. Bring the motor to the intermediate position. on the intermediate position. 02. While press STOP also press PROG for until the 02.
Page 11
Tel. (+39) 0546.624811 - Fax. (+39) 0546.623141 - www.stafer.com All products and technical specifications given in this document are subject to variation without notice. Unless previously and specifically authorised by STAFER, the device must be used exclusively with transmitters produced by STAFER.
Need help?
Do you have a question about the 593.K.RS.00 and is the answer not in the manual?
Questions and answers