Maintenance And Adjustments - Kingfisher 3125 GFX OFFSHORE Owner's Manual

MAINTENANCE AND ADJUSTMENTS

Periodic Inspection Checklist
❏ Check entire fuel system for leaks
❏ Check all engine mount fasteners for tightness
❏ Check all deck fasteners for tightness
❏ Inspect hull and motor mounts for cracks and
other signs of fatigue such as deep scuffing
❏ Check drain plug
❏ Check bilge for oil, water and gasoline
❏ Check steering lines for wear and ease of function
❏ Check oil level in engine and power steering pump
❏ Test battery and check for damage or corrosio
❏ Test all switches, lights, horn, and accessories
❏ Check for burnt out lights
❏ Check seat fasteners and swivels
for tightness and wear
❏ Inspect zinc hull anode and replace if required
❏ Confirm proper operation of galvanic isolator.
See page 30 of this manual
Inspecting the Fuel System
The fuel system can be accessed through removable
panels in the transom and in the deck. Remove the
panels and check the fill fitting, the tank fittings and
the vent lines at the filler cap and at the tank for signs
of leakage Also check the hoses and primer bulb
(if equipped) for signs of wear, chafing and other
deterioration Replace any damaged fuel hoses
immediately. Check the fuel filters. Change the filters
once a season or after every 100hrs of operation.
GASOLINE VAPORS CAN EXPLODE IF IGNITED, CAUSING SERIOUS INJURY OR DEATH
INSPECT FUEL SYSTEM FOR LEAKS REGULARLY
18 KINGFISHER BOATS
|
3125 3425 OWNERS MANUAL
Inspecting the Steering
Your boat will come with an owner's manual for the type
of steering system that your boat is equipped with Refer
to this manual for information on proper maintenance
Never operate your boat with a damaged or improperly
functioning steering system. Confirm that the hydraulic
reservoir is full, and check all hoses and connections are
leak-free and that the fluid isn't contaminated.
Inspecting the Circuit-Breakers and Fuses
Your boat is equipped mainly with resettable circuit
breakers. These will pop out if overloaded and can be
pushed back in with a fingertip to reset them. There is an
in-line grey 50A circuit breaker coming off the main battery
lead to your distribution panel Inspect the fuses and the
electrical system of your boat monthly. You can also find
a panel of fuses under the main helm Shut off the main
electrical switch by your battery (or disconnect the battery)
and inspect the accessories Trace the circuits and inspect
them for chafing and for broken or damaged wires, plugs,
switches or connectors. Never bypass a fuse or circuit
breaker. If you are unable to find the cause of the blown
circuit, have your boat serviced by your Kingfisher dealer.
Servicing Under the Deck
Access to the bilge and fuel tank is gained by removing
all the sidewalk screws and lifting the rear deck off
Transducer Mounting Plates
Transducer brackets are a standard design feature They
are intended to reduce the need to drill holes directly into
the hull below the water line The plates are located at
the base of the transom, where the hull meets the rear of
the boat Simply attach your transducer(s) directly to this
plate on the transom Do not drill holes for routing cables
below the water line Extreme caution must be used when
installing this type of transducer to avoid leakage and
potential injury or death
WARNING: