Summary of Contents for Celerity Surface Line Rotatable Series
- Page 1 Surface Line Rotatable (SLR) Series Pressure Transducer Display User Guide Celerity, Inc. 915 Enterprise Boulevard Allen, TX 75013 USA T +1 972 359 4000 F +1 972 359 4100 A331289 REV. 001 8/07...
-
Page 2: Table Of Contents
_CONTENTS _1.0 INTRODUCTION _1.1 INTRODUCTION _1.2 INTENDED USE _2.0 OPERATING SPECIFICATIONS _2.1 OPERATING SPECIFICATIONS _3.0 INSTALLATION _3.1 SLR PRESSURE TRANDUCER DISPLAY DIMENSIONAL DRAWING & PINOUTS _3.2 MECHANICAL INSTALLATION _3.3 ELECTRICAL CONNECTION _3.4 DISPLAY ALIGNMENT _3.5 MODE SETTING _3.6 CALIBRATION _3.7 REMOVAL AND REPLACEMENT _4.0 WARRANTY p. -
Page 3: 1.0 Introduction
_INTRODUCTION 1.1 FUNCTION This manual covers the Surface Line Rotatable (SLR) Series Pressure Trans- ducers as shown in Figure 1 below. Included herein is general information, oper- ating specifications, installation and removal instructions, and product warratny information. Figure 1. Surface Line Rotatable (SLR) Pressure Transducer Displays 1.2 INTENDED USE The SLR Pressure Transducer Display is a miniature digital transducer display for use on 1.125 inch surface substrate. -
Page 4: 2.0 Operating Specifications
_OPERATING SPECIFICATIONS 2.1 OPERATING SPECIFICATIONS Materials Display Type Light Emitting Diode (LED) Display Height 0.3 inches Housing Metallized Plastic Connections Electrical Connection 15-pin D-Sub Transducer Connector 15-pin D-Sub Performance Accuracy ±1 Display Count Linearity +1 Display Count Thermal Sensitivity 0.2 Display Counts/°C Operating Conditions Range 30 PSI (207 KPa) -
Page 5: 3.0 Installation
_INSTALLATION 3.1 SLR PRESSURE TRANSDUCER DISPLAY DIMENTIONAL DRAWINGS & PINOUTS 28.58 1.13 PSIA MODE 30.48 1.20 28.58 Ø 1.13 CAUTION The connection should be con- ducted with no power being present to the available connec- tions. 47.75 1.88 INPUT/OUTPUT INTERFACE TRANSDUCER INTERFACE Figure 2. -
Page 6: 3.2 Mechanical Installation
Inspect but DO NOT discard. unwrap any parts until instal- lation. Contact your Celerity 2. Follow standard cleanroom entry procedures where applicable. representative with any prob- lems. 3. Install the display on the transducer. Be sure to hold the display with the D- Sub connector “in-line”... -
Page 7: 4.0 Warranty
Allen, TX 75013 USA Celerity is a trademark of Celerity of Celerity, Inc. All other product or service names mentioned in this document may be trademarks of the companies with which they are associated. System descriptions are typical and subject Telephone 972.359.4000...
Need help?
Do you have a question about the Surface Line Rotatable Series and is the answer not in the manual?
Questions and answers