Advertisement
Using a Qrelay in a Project.
The intended use of the Qrelay is to extend the range of a remote, Qsync or Qconnect. Any transmitter
has a limit on how far it will reliably control a shade. The Qrelay allows this distance to increase so that
better results may be achieved.
Locate Qrelay pointing up, as far from the floor
as possible, within shades' line of sight for best
results. The best position may require trial and
error.
How Qrelay Will Operate
Qrelay will wait 60 seconds to receive
communication from any remote to set its
mode upon being powered. The Qrelay
light will stay lit. If no command is received
in that time, it will be set to the last known
mode state. Then the Qrelay light will go
out. Factory Default mode for Qrelay is
Echo All Mode.
Qrelay will echo any command
it receives from a QMotion
Roller Shade remote.
Qrelay will echo only the
commands it has received
from QMotion Roller Shade
remotes/channels learned to it.
A maximum of two remotes/
channels can be learned to Qrelay.
Qrelay
Plug Qrelay into any powered USB
compliant jack. (Our optional wall adapter
shown.) The Qrelay will not function if the
USB jack is not powered.
How To Set This Mode
Plug in Qrelay. Do not press any remote
buttons. Wait for the Qrelay light to go out.
Qrelay has now assumed its last known
mode state. This means that if you have
previously set Qrelay and do not wish to
change the mode, Qrelay has remembered
your previous settings.
Plug in Qrelay. The Qrelay light will
illuminate. Press and release 50% button
on any Qmotion Roller Shade remote within
range of Qrelay. The Qrelay light will go out.
Plug in Qrelay. Then press and release the
25% button on the desired QMotion Roller
Shade remote/channel. The Qrelay light
will pulse. Then press and release the UP
button. The Qrelay light will go out.
To add a second remote/channel, unplug
Qrelay and plug it in again. Select the new
QMotion Roller Shade remote/channel.
Press and release the 25% button on this
remote/channel. The Qrelay light will pulse.
Then press and release the UP button on
this remote/channel. The Qrelay light will
go out.
Qrelay
Light
USB Jack
Advertisement
