Advertisement
3. SPeCIfICaTION
Model No: ................................................................ e/STaRT1600.V2
Output: ..................................................................... 12V
Output start Peak(EN): ............................................. 1600A(800A)
Maximum Starting Capacity: ..................................... Petrol: 6ltr, Diesel: 4ltr
Weight: ..................................................................... 2.3kg
Accessory ................................................................. E/START2A Digital ElectroStart® Smart Charger Adaptor 15V 2A
4. CONTROL PaNeL
fig
:
5. OPeRaTION
5.1.
DUTy CyCLe
After 5 starts let the unit rest for 15 minutes.
5.2.
PRePaRaTION
Turn off headlights, air conditioning, heated screens, audio etc.
5.3.
BUZZeR
5.3.1.
Intermittent buzzing indicates the E/START is ready to start vehicles.
5.3.2.
Continuous buzzing means there is an error.
5.4.
STaNDaRD MODe
In most situations a weak battery on the vehicle can fully recharge the E/START.
Connect clamps to the battery terminals, E/START will turn on automatically and the display will show the voltage of the vehicle's
battery, see fig.1.
5.4.1.
Press ON/OFF and the E/START starts to recharge itself. The display shows the E/START's percentage, see fig.2.
5.4.2.
After the ignition sign appears, see fig.3, turn on the engine.
When the engine fires, remove the E/START as soon as possible.
5.5.
ByPaSS MODe
5.5.1.
In some situations the E/START may fail to start the car because the vehicle's battery is too weak. Press ON/OFF for a few
seconds to activate BYPASS MODE.
5.5.2.
After the ignition sign, fig.3 appears, turn on the engine as soon as possible.
5.6.
PRe-CHaRGe MODe
5.6.1.
If the battery is too weak to charge the E/START, fig.7 will appear.
5.6.2.
Connect the E/START to a good battery until the unit is fully charged, then remove.
5.6.3.
Connect the E/START to the weak battery, the display shows the voltage in that battery.
5.6.4. .
Press the ON/OFF switch to activate. Fig.3 is now displayed.
5.6.5.
Turn the engine on.
5.6.6.
Remove the unit as soon as the engine fires.
© Jack Sealey Limited
fig.10
Original Language Version
Original Language Version
E/START1600.V2 Issue: 3 (5) - 29/04/19
Advertisement
