Advertisement
W150W
Applications Guide
Applications Guide
The wireless repeater extends the signal range
of many of PRO1's wireless products. When
the W150W receives a coded wireless signal,
it repeats it to extend the wireless range of the
device.
RF Frequency
916 MHz
Power Type
Hardwire (Common Wire)
24V AC (18-30V)
Important Communication
Mode Note:
When using this product, any and all
components/devices of the system that
contain a selectable communication
mode (FSK/ASK Jumper Pin Switch),
MUST be set to ASK.
® U.S. Registered Trademark. Patents pending.
Copyright © 2011 PRO1 IAQ, Inc. All rights reserved.
®
REPEATER
INSTALLATION MANUAL
A trained, experienced technician
must install this product.
Carefully read these instructions. You
could damage this product or cause a
hazardous condition if you fail to follow
these instructions.
Table of Contents
Subbase Installation & Wiring
Speci cations & Contact Info
Need Help?
For assistance with this product please
visit http://www.pro1iaq.com or call Pro1
Customer Care toll-free at 888-Pro1iaq
(776-1427) during normal business hours
(Mon-Fri 9 AM - 6 PM Eastern)
Page
2
3
4
5
Rev. 1344
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Pro1 IAQ W150W
- Page 1 (776-1427) during normal business hours mode (FSK/ASK Jumper Pin Switch), (Mon-Fri 9 AM - 6 PM Eastern) MUST be set to ASK. ® U.S. Registered Trademark. Patents pending. Copyright © 2011 PRO1 IAQ, Inc. All rights reserved. Rev. 1344...
- Page 2 COMMUNICATION QUICK REFERENCE Getting to know the W150W Module Antenna symbol Transmit symbol indicates indicates received repeating signal. signal. When the W150W receives a wireless signal to repeat, the Recieved Symbol will ash. After a few seconds the Red Indicator Light and the Transmit Symbol will ash.
- Page 3 Wireless Module - Installation Wireless Range Range between the W150W module and the devices to be repeated is approximately 100 feet with no obstructions and approximately 50 feet in standard residential construction. Place the W150W Repeater somewhere between communicating devices to repeat the wireless signal and extend the range.
- Page 4 SUBBASE INSTALLATION & WIRING Wiring Module to Power Supply Caution: Electrical Hazard Failure to disconnect the power The W150W must be hardwired (C and R terminals before beginning to install this connected to 24VAC power). product can cause electrical shock or equipment damage.
- Page 5 60 days of installation. You can register your new product in 2 ways. Go to www.pro1iaq.com, select warranty registration and ll out a short registration form. - or - Complete the form below and mail it to the address shown. Pro1 IAQ Warranty Registration: Name: ____________________________ Thermostat Model:...
Need help?
Do you have a question about the W150W and is the answer not in the manual?
Questions and answers