Earth Terminal - Fuji Electric DB C Series Instruction Manual

•Check the wiring again before operating the inverter. Improper wiring may cause unexpected inverter operation or
device operation. There is a risk of accident or injury.
• Since noise is generated by the inverter, motor, and wiring, carefully monitor surrounding sensors
and devices for abnormal operation. There is a risk of accident.
Applicable
DB0.75-2C
DB2.2-2C/DB3.7-2C
DB5.5-2C/DB7.5-2C
DB11-2C～DB22-2C
DB0.75-4C
DB2.2-4C～DB22-4C
Note 1:The size of the use electric wire is based on 600V vinyl electric wire.（Please use heatproof 75℃ or more.）
Note 2:The wiring length is assumed to be 5m or less.
Recommended connection method
Terminal for braking resistor connection
Type
0.75mm
DB0.75-2C
(CFGE)
DB0.75-4C
The wiring for 500mm is attached.
DB2.2-2C/DB3.7-2C
Connected bar
DB2.2-4C/DB3.7-4C
Board thickness2mm
DB5.5-2C/DB7.5-2C
Φ4.3mm Installation hole
DB5.5-4C/DB7.5-4C
Connected bar
DB11-2C～DB22-2C
Board thickness2mm
DB11-4C～DB22-4C
Φ6mm Installation hole

Earth terminal

Type
All models
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
3-3 Wiring
CAUTION
Table 3-3-1
Model
Table 3-3-2
Terminal form
2
Electric wire
Table 3-3-3
Terminal form
Ｍ４ Terminal
(With screw）
Use electric wire size
2
2mm
2
2mm
3.5mm
5.5mm
2
2mm
2
2mm
Connection method
Please connect the terminal with wiring.
Please connect wiring in connected bar with the bolt
and the nut.
Connection method
Please connect wiring with the earth terminal.
5
2
2