Riello NetMan 204 Quick Reference Installation Manual

DESCRIPTION
NetMan 204 is a device that allows UPS management through a LAN (Local Area Network); the
accessory supports all the main network protocols (SNMP v1 and v3, TCP/IP, HTTP and so on)
and is compatible with Ethernet 10/100Mbps IPv4/6 networks. The UPS can therefore be
integrated easily into medium and large-sized networks.
The device also records UPS values and events in the history log archive and can manage
optional environmental sensors (not supplied with the device, but provided separately)
NOTE: for the comprehensive user manual refer to the CD-ROM supplied.
F
RONT PANEL
100Mb
Network port
NetMan 204 connects to 10/100 Mbps Ethernet networks by means of connector RJ45. The LEDs
built into the connector describe the status of the network:
Left LED:
SOLID YELLOW: NetMan204 has detected a valid link.
FLASHING YELLOW: NetMan204 is receiving or transmitting data packets.
Right LED
SOLID GREEN: NetMan204 is connected to a network operating at 100 Megabits per second.
Micro-USB port
NetMan 204 makes available an USB communication port through which it is possible to configure
it (see paragraph "Configuration via USB").
Serial port
NetMan 204 makes available a serial communication port to which you can connect environmental
sensors (not supplied with the device, but provided separately) or a modem (not supplied with the
device) for UPS teleservice.
Led
This led describes the status of NetMan 204:
SOLID RED: NetMan 204 is not communicating with the UPS (verify PRTK Code).
FLASHING RED: the DHCP server does not have assigned a valid IP address to NetMan 204.
OFF: regular working.
Reset button
The reset button allows to restart the NetMan204 or to load a default configuration with a
predefined static IP address.
To reset NetMan204: keep press the reset button until the red led start flashing (ca. 2 seconds)
and then release it.
To load a configuration with predefined static IP address: keep press the reset button; first the
led starts flashing, then turns to solid red (ca. 10 seconds). When the led is solid red, release the
reset button and the NetMan 204 will reboot with:
IP address: 192.168.0.204
Netmask:
SSH service enabled
HTTP service enabled
HTTP and SSH service are enabled temporarily without changing the configuration saved
in non-volatile memory.
U
SERS
It is possible to access to NetMan 204 with three different users (admin / fwupgrade / user).
Username
admin
fwupgrade
user
QUICK REFERENCE INSTALLATION MANUAL
255.255.0.0
Default password
admin
fwupgrade
user
Privileges
user with right to modify the configuration
user with right to upgrade the firmware
user with right to read and download the log files
NETWORK ADAPTER
A: Network port
B: Led
C: Reset button
D: Micro-USB port
E: Serial port