Dakota Digital LDM-CA01 Quick Start Manual

BODY PANEL WITH HOLE CUT
FOR LIGHT
LIGHT HOUSING
GASKET
Thank you for purchasing Dakota Digital LED marker lights, please take a moment to inventory your
parts and installation hardware. The Marker lights are shipped with all of the necessary components
to mount them. As shown in Figure 1 above:
2 Light assemblies
2 Mounting cups
2 Gaskets
3 Locking # 4- 40 nuts
6 Push-lock connectors
Installation
1. Determine mounting location and position for the lights. Verifying there is enough room behind
the panel/body for the lights and a safe place to route the wires where they will not be cut or
wear due to vibrations/movement.
2. Cut out the appropriate template from the 3 styles provided and tape it to the body in the
desired location. Using the template as a guide, cut the hole using the appropriate tools. Start
by cutting just inside the black line, test fitment, and trim as necessary for a snug fit. Be
extremely careful to avoid cutting any material outside of the gray lines as this would be visible.
3. Use the hardware supplied to secure the marker light into the body. First, install the gasket
around the light, then feed the wires through the hole and slide the marker light into place.
Place the clamp over the studs and secure it using the supplied lock nuts. Tighten until snug.
See the figure above if you have any questions.
MAN#650162
Dual Intensity LED Marker Lights
LDM-CA01
LDM-CA25
LDM-CA50
MOUNTING CUP
LOCKING NUTS
#4-40
BLUE BLACK VIOLET
+12 V GROUND +12 V
FOR LOW FOR HIGH
BRIGHTNESS BRIGHTNESS
LDM-CR01
LDM-CR25
LDM-CR50
BLUE BLACK VIOLET
+12 V GROUND +12 V
FOR LOW
FOR HIGH
BRIGHTNESS BRIGHTNESS
1