ETC Echoflex Installation Manual

Echoflex Installation Guide
EchoConnect Cat5 Termination Box
Overview
The EchoConnect
wall or flat vertical surface, typically near or directly next to a wall-mount
Elaho Station Power Supply.
This termination box facilitates termination of up to 16 runs of Category 5
(or equivalent) cable on the EchoConnect communication bus.
The following supplies are included for installation convenience:
6 ft (1.8 m) of Belden 8471 cable
•
Six position screw terminal connector J3263-F (x1)
•
For use with Echoflex dimming and relay products..
Mount Box to Wall
This termination box is provided with four knockouts on each long side,
sharing the same conduit entry locations as the wall mount Elaho Station
Power Supply. All wiring terminations are accessible from the front with
the cover removed. If you are mounting this box directly next to the wall
mount Elaho Station Power Supply, use appropriate attaching hardware
and wire protection hardware (not provided).
1. Remove the six screws securing the front cover to the box.
2. Align the unit to the wall and mark the mounting keyholes.
Alternatively, reference the adjacent dimensioned drawing.
3. Drill the mounting holes and install the mounting hardware (not
provided). Expose at least 3/4" (19 mm) of threads for mounting
the unit.
4. Attach the termination box to the mounting hardware, where the
back side of the unit is flush to the wall, then tighten the mounting
hardware.
Rough-In Conduit and Wiring
Note:
jurisdiction requirements. Follow all local codes and restrictions.
Terminations include:
EchoConnect (Belden 8471 twisted pair) installed between this termination box and the
•
adjacent Elaho Station Power Supply. This wire pair is provided.
Category 5 (or equivalent) cable installed between this termination box and each EchoConnect
•
wire run. Up to 16 runs of EchoConnect are supported.
ESD ground wire, 14 AWG (2.5 mm
•
ground bar) and any Elaho product (Class 2 only) on the communication bus that is not installed
entirely in grounded metal conduit.
®
Cat5 Termination Box is intended for installation on a
NEC C lass 2 product to be wired in accordance to NEC Article 725 and local
Main Office
Email info@echoflexsolutions.com
subject to change.
8186M2130
2
) is recommended, between this termination box (ESD
Squamish, BC, Canada Toll Free +888 324 6359
n n
Web echoflexsolutions.com
n
©2018 Echoflex Solutions, Inc.
n
Revision A Released 2018-09
n n
Phone +778 733 0111
n
Product information and specifications
n
Echoflex intends this document to be provided in its entirety.
n
6' (1.8m)
included
14"
356 mm
11.5"
292 mm
4" 3.15" deep
(80 mm)
102 mm
Fax +604 815 0078
n