Philips SWS2100W/27 Owner's Manual page 4

5 Connections
Follow these steps to connect your RF Modulator:
Connect an S-Video or video cable between the S-Video or video
1
output jack on your video source and the
RF Modulator's S-VIDEO or VIDEO IN jack. 1
1. VIDEO IN Jack
2. S-VIDEO IN Jack
3. Video Output - (or)
4. S-Video Output
5. Video Source
D Note
If both the S-Video and standard video are hooked up, the
S-Video will be given priority
Connect an audio cable between the audio output jacks on your
2
video source and the RF Modulator's AUDIO IN jacks. 2
1. AUDIO IN Jacks
2. Audio Output
3. Audio Source
Connect the 75-ohm coaxial cables to the RF Modulator using one
3
of these two (2) options:
Option 1: If your TV is already connected to another VHF input
source (such as cable TV, VCR, etc.): 3
1. RF Modulator
2. VCR
3. CATV/ANT
4 TO TV
5. Disconnect from here
a. Disconnect the current CATV/antenna connection from the
75-ohm input terminal of your VHF source, and reconnect it to
the RF Modulator's ANT IN terminal.
b. Then add a 75-ohm coaxial cable connected between the TO TV
terminal of the RF Modulator and the 75-ohm input terminal of
your VHF source. 4
1. RF Modulator
2. Reconnect here
3. VCR
4. CATV
5. Add this cable
6. To TV
Option 2: If your TV is not already connected to another VHF
source: 5
1. RF Modulator
2. TV
3. CATV
a. Disconnect the current CATV/antenna cable from the 75-ohm
input terminal of your TV, and reconnect it to the RF Modulator's
ANT IN terminal.
b. Then add a 75-ohm coaxial cable connected between the TO
TV terminal of the RF Modulator and the 75-ohm VHF input
terminal on your TV.
D Note
If your TV has only 300-ohm VHF screw terminals, use a
75-ohm-to-300-ohm matching transformer to complete the
connection.
Plug the RF Modulator's power cord into a standard AC outlet.
4