Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Lilin PIH-302C
Summary of Contents for Lilin PIH-302C
- Page 1 INDOOR PAN/TILT WITH CONTROL PIH-302/302C INSTRUCTION MANUAL...
- Page 2 CAUTION The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the RISK OF ELECTRIC SHOCK presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT OPEN COVER.
-
Page 3: Table Of Contents
PREFACE Thank you for choosing PIH-302 Indoor Pan/Tilt. For trouble free installation and optimum performance please read this manual thoroughly before attempting installation or operation. TABLE OF CONTENTS PAN/TILT UNIT INSTALLATION WIRING OF UNIT INVERTED MOUNTING ADJUSTING LIMIT STOPS MAINTENANCE CONTROLLER FRONT/REAR PANEL WIRING OF PAN/TILT... -
Page 4: Pan/Tilt Unit
PAN/TILT UNIT INSTALLATION The PIH-302 is intended to be mounted on a PIH-5003 wall Mount. Installation of the pan and tilt drive to the wall mount requires a stainless steel 1/4-20 screw supplied with the wall mount. Note the ribs on the underside of the PIH-302 base engage slots in the PIH-5003. -
Page 5: Adjusting Limit Stops
ADJUSTING LIMIT STOPS After cable is installed and unit has been mounted, proceed as follow: 1. Plug control unit into a 117Va.c.(optional 230Va.c./24Va.c.) source. Be sure auto switch is in the OFF position. 2. To adjust pan limit stops (see Figure 2), loosen screws securing both stops(1) and (3) to unit. -
Page 6: Controller
Slide the bracket up and tighten the screw. AUTO COMMON TILT DOWN TILT UP PAN LEFT PAN RIGHT Figure 4 Interconnection Diagram, PIH-302C Control Fabricate interconnecting cables according to appropriate cable assembly diagram (Figure 4). -
Page 7: Operation
OPERATION Energize the control unit by plugging the line cord into a power source of the appropriate voltage. The red power indicator light will illuminate. PAN AND TILT Pan is horizontal change in camera direction, moving the field of view to the left or right. Tilt is a vertical change in camera direction, raising or lowering the field of view. -
Page 8: System Installation
SYSTEM INSTALLATION RIGHT LEFT DOWN AUTO Figure 5 Interconnection Diagram, PIH-302 Control UPPER VIEW (Inside of the unit) Figure 6 Interconnection Diagram, PIH-302... -
Page 9: Specification
Finish Off white baked enamel finish Dimensions 184 (H) x 115 ( Weight 1.9 kgs PIH-302C INDOOR PAN/TILT CONTROL Control Buttons Auto / Off / Manual, Left / Right, Up / Down Input Voltage a.c. 117V/230V, 50Hz/60Hz Output Voltage a.c. 24V/117V/230V, 50Hz/60Hz... - Page 10 MERIT LILIN ENT. CO., LTD http://www.meritlilin.com 66-302CSE...