Advertisement
Z260W
Pro1 Technologies, Inc.
PO Box 3377
Spring eld, MO 65804
Toll-Free: 888-776-1427 Web: www.pro1iaq.com
Hours of Operation: M-F 9AM - 6PM Eastern
This manual is used
to setup damper modules:
• Z260W
(Requires Z955W for Master
Zone (zone 1) and RZ251W
for additional zones)
Congratulations on purchasing
our Wireless Zoning System.
This Damper Module was designed to the
highest reliability and ease of use standards.
Thank you for choosing our quality products.
Table of Contents
Power Type
24 VAC (Hardwire)
® U.S. Registered Trademark. Patents pending.
Copyright © 2014. All rights reserved.
INSTALLATION MANUAL
A trained, experienced technician
must install this product.
Carefully read these instructions. You
could damage this product or cause a
hazardous condition if you fail to follow
these instructions.
Page
2
3
4
5
Caution:
Equipment damage hazard
Do not operate the cooling
system if the outdoor
temperature is below 50˚ F
(10˚ C) to prevent possible
compressor damage.
Rev. 1407
1
Advertisement
Table of Contents
Summary of Contents for Pro1 Technologies Z260W
- Page 1 INSTALLATION MANUAL Caution: Equipment damage hazard Z260W Do not operate the cooling system if the outdoor Pro1 Technologies, Inc. temperature is below 50˚ F PO Box 3377 (10˚ C) to prevent possible Spring eld, MO 65804 compressor damage. Toll-Free: 888-776-1427 Web: www.pro1iaq.com...
- Page 2 WIRING QUICK REFERENCE Damper Module(s) Caution: The Damper Module is designed to operate with 24VAC Electrical Hazard 2-wire and 3-wire zone dampers. Failure to disconnect the power before beginning to install this The Damper Module(s) must be hardwired with 24VAC product can cause electrical shock connected to R and C.
- Page 3 WIRING WIRING Damper Module(s) 24VAC Transformer Caution: Electrical Hazard Failure to disconnect the power before beginning to install this product can cause electrical shock or equipment damage. Motorized Damper 24VAC Normally Closed L1 (HOT) Motorized Damper 24VAC Normally Open L1 (HOT) Motorized Damper 24VAC Power Open/ Power Close OPEN...
- Page 4 ESTABLISHING COMMUNICATION Back of Damper Module FSK/ ASK Switch Remember This Wireless Zoning System contains selectable wireless communication. Each component has a jumper switch labeled FSK and ASK. Default setting: FSK. All components must be set to the same position for wireless communication.
-
Page 5: Speci Cations
SPECIFICATIONS & CONTACT INFORMATION Speci cations Damper Module 3 amps per terminal/3 amps total Load rating 18 to 30 VAC, NEC Class II, 50/60 Hz Power source 32ºF to +105ºF (0º to +65ºC) Operating ambient 90% non-condensing maximum Operating humidity...
Need help?
Do you have a question about the Z260W and is the answer not in the manual?
Questions and answers