Placing The Controller Back Into Its Enclosure; Final Steps - DDN Storage SFA7700 Series How-To Manual

2. Pivot the top of the controller case to prevent damage to the CMOS battery wires and slip
into position onto the bottom half of the controller enclosure.
3. Insert and tighten the two screws on the front of the controller.
4. Insert and tighten the four screws on the side of the controller.
5. Place the new warranty stickers in the same position as they old ones.

Placing the Controller Back into Its Enclosure

1. Carefully insert the controller into the empty bay, applying equal pressure on either side as
the lock bar is engaged.
2. Finish pushing the lock bar into position.
3. Secure the thumbscrew.
4. Once in the enclosure, the controller should power up automatically.
5. Reattach the cables to the host ports and SAS ports in their original placement and order.

Final Steps

1. Log into the controller which has the new batteries.
2. When the controller has fully booted, verify the manufacturing date with the command
SHOW UPS <enclosure ID> <UPS index> ALL
For example:
SHOW UPS 0 1 ALL
The resultant output should look similar to the following (Figure 22):
© 2016 DDN STORAGE. P/N 15-000836-001 SFA7700 CMOS and Backup Battery Replacement Instructions | 17