Related Manuals for NexDome 2.2m Shutter Motor Kit
Summary of Contents for NexDome 2.2m Shutter Motor Kit
- Page 1 2018-01-31 4:45 PM NexDome 2.2m Shutter Motor Kit Installation and Operation Manual...
- Page 2 NEXDOME OBSERVATORIES NEXDOME.COM 1-Replace the nylock nuts with the ¼” coupler on the two locations shown in Fig. 1 on the right side of the dome, facing the slit from inside. Ver.1.1 Page 2...
- Page 3 NEXDOME OBSERVATORIES NEXDOME.COM 2- Remove the shutter handle and install the shutter motor with the same screws and nuts. 3- Connect the Battery Power. Important Note: Avoid the connection between the two magnetic receptacles on the shutter motor unit. This will destroy the unit electronics. When un-assembling or installing the unit, disconnect the Battery Power to avoid such connection.
- Page 4 NEXDOME OBSERVATORIES NEXDOME.COM Fasten the track to the coupler with the provided screw on the track end. Fasten the track to the coupler with the provided screw on the other end of the track. Ver.1.1 Page 4...
- Page 5 NEXDOME OBSERVATORIES NEXDOME.COM Attach the magnetic the “Close” magnetic sensor in front of the shutter magnet on the rim of the shutter slit. Move the shutter to fully open position and attach the magnetic the “Open” magnetic limit sensor in front of the shutter magnet on the edge of the dome back panel.
- Page 6 NEXDOME OBSERVATORIES NEXDOME.COM Park your dome first and close the shutter. Attach the charging station with the provided hardware to the dome exactly under the shutter motor unit in a way that magnetic receptacles can easily connect. Notes: Once the unit is powered, it will connect automatically to the dome controller •...
- Page 7 NEXDOME OBSERVATORIES NEXDOME.COM not in use. If for any reason, the battery is discharged in an open position, disconnect • the battery power and use your dome controller adapter and connect power the shutter unit in order to move it to close position to connect to charger station.
Need help?
Do you have a question about the 2.2m Shutter Motor Kit and is the answer not in the manual?
Questions and answers