Advertisement
Quick Links
When using this electrical equipment, basic safety precautions should be followed, including:
•
READ AND FOLLOW ALL INSTRUCTIONS
•
Disconnect all AC power during installation.
•
Warning – To reduce the risk of injury, do not permit children to use this product unless they are closely
supervised at all times.
•
SAVE THESE INSTRUCTIONS
INTRODUCTION
Prior to Revision L of the Jandy AquaLink® RS, the AquaLink® RS could control the Hayward®/GoldLine Aqua Rite®
through the control panel (AquaLink® One Touch™, AquaLink® PDA, or AquaLink® Touch™). Revision L and forward,
Jandy has chosen to no longer control the Aqua Rite® through the control panel. The Chlorinator Translator permits the
AquaLink® RS to control the Aqua Rite® through the control panel without modifying either the AquaLink® RS or the
Aqua Rite®.
The Chlorinator Translator is designed to allow the AquaLink® RS to communicate with your chlorine generation system.
This permits the ability to control chlorine level and SUPER CHLORINATE (Boost Pool). The Chlorinator Translator also
reports error(s) back to the AquaLink® RS. Refer to your AquaLink® RS manual on how it shows you errors. Read your
chlorine generation system manual on how to use it.
OPERATION
If you are installing your chlorine generation system for the first time, do this FIRST, following manufacturer's installation
instructions. After the chlorine generation system is properly installed, the Chlorinator Translator may be installed.
DO NOT CONNECT YOUR AQUALINK® RS TO THE AQUA RITE® AT THIS TIME.
The Chlorinator Translator has a Link Status LED. When the LED is blinking the Chlorinator has power and is functioning,
but there is no active communication with AquaLink® RS or Aqua Rite®. Once the AquaLink® RS and Aqua Rite®
communication is established, the Link Status will be solid. Also, the AquaLink® RS or Remotely Controlled LED on the
Aqua Rite® will be lit. You can now control your Aqua Rite® through the AquaLink® RS control panel.
Chlorinator Translator Rev 1.3
By Flynn Engineering, LLC
IMPORTANT SAFETY INSTRUCTIONS
Advertisement
Summary of Contents for Flynn Engineering Chlorinator Translator
- Page 1 DO NOT CONNECT YOUR AQUALINK® RS TO THE AQUA RITE® AT THIS TIME. The Chlorinator Translator has a Link Status LED. When the LED is blinking the Chlorinator has power and is functioning, but there is no active communication with AquaLink® RS or Aqua Rite®. Once the AquaLink® RS and Aqua Rite®...
- Page 2 Depending on the revision of the Chlorinator Translator hardware and software, the lights have the following meaning: Revision Green Blue Description Check All Hardware Blinking Power on, neither If it remains this and Software. Aqua Rite® nor way after 1 AquaLink®...
- Page 3 The AquaLink® RS and the chlorine generation system use a 4 wire connection to communicate. Any outdoor rated 4 conductor cable can be used. Refer to the Jandy instructions and the wiring diagrams below, and the Aqua Rite® instructions and the wiring diagrams below for proper wiring connection to the Chlorinator Translator. GREEN...
- Page 4 “AUTO” LED will start to blink. In another 30 seconds the “AUTO” LED will be solid again. 3) About 20 seconds later the Chlorinator Translator will have a solid green light. If not, refer to the Figure 1 Chart.
-
Page 5: Limited Warranty
Thank you for purchasing the Chlorinator Translator by Flynn Engineering, LLC. Flynn Engineering, LLC warrants all parts of the Chlorinator Translator to be free from manufacturing defects in materials and workmanship for a period of one (1) year from the date of retail purchase.