Download Print this page

Vision ZL 7261 CL-5 Operation Manual

Z-wave power monitor

Advertisement

Quick Links

Federal Communications Commission Statement
This equipment has been followed to comply with Part 15 of the FCC Rules. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try and correct the
interference by one of the following measures:
-Reorient or relocate the receiving antenna,
-Increase the separation between the equipment and receiver,
-Connect the equipment into and outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesirable operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
Limited Warranty
Vision Guarantees that every wireless lighting module is free from physical defects in material
and workmanship under normal use for one year from the date of purchase. If the product
proves defective during this one-year warranty period, Vision will replace it free of charge.
Vision does not issue any refunds. This warranty is extended to the original end user purchase
only and is not transferable. This warranty does not apply to: (1) damage to units caused by
accident, dropping or abuse in handling, or any negligent use; (2) units which have been
subject to unauthorized repair, taken apart, or otherwise modified; (3) units not used in
accordance with instruction; (4) damages exceeding the cost of the product; (5) transit
damage, initial installation costs, removal cost, or reinstallation cost.
For information on addional devices, plesae visit us at www.visionsecurity.com.tw
ZL7261-5
V0
1070301
Operation Manual
ZL 7261 CL-5
ZL 7261 CN-5
ZL 7261 DE-5
ZL 7261 FR-5
ZL 7261 IT-5
ZL 7261 JP-5
ZL 7261 KR-5
ZL 7261 RU-5
ZL 7261 US-5
Z-Wave Power Monitor

Advertisement

loading

Summary of Contents for Vision ZL 7261 CL-5

  • Page 1 Vision will replace it free of charge. ZL 7261 CN-5 Vision does not issue any refunds. This warranty is extended to the original end user purchase ZL 7261 DE-5 only and is not transferable. This warranty does not apply to: (1) damage to units caused by ZL 7261 FR-5 accident, dropping or abuse in handling, or any negligent use;...
  • Page 2 Introduction Protocol: Z-Wave (ZM5202) 1pc Power Monitor f Module Thanks for choosing the Vision’s Power Monitor of the home automation device. This Power Monitor Frequency: 1pc User Manual Module is a Z-Wave enabled device (interoperable, two-way RF mesh networking technology) and is 865.22MHz (ZD2112IN-5)
  • Page 3 8. Configuration: Operation Parameter Size Value Notes If you are installing the entire Z-Wave system for the first time, please refer to the installation guide of Z-Wave Interface Controller before installing ZL7261. Auto report 1 ~ 120 minutess Report 1 byte timing (Default 1 minute ) kWh/kVAh...

This manual is also suitable for:

Zl 7261 fr-5Zl 7261 de-5Zl 7261 cn-5Zl 7261 it-5Zl 7261 jp-5Zl 7261 ru-5 ... Show all