Page 1
Form No. 3422-358 Rev B Trimmer Mount Kit Z Master ® 3000, 5000, or 6000 Series Riding Mower Model No. 137-9769 Installation Instructions Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger.
Installation Preparing the Machine No Parts Required Procedure Park the machine on a level surface. Move the motion-control levers to the N position. EUTRAL Engage the parking brake. Shut off the engine and remove the key. g037289 Figure 1...
Page 3
Assembling the Upper Installing the Support Trimmer Mount Assembly Bracket Parts needed for this procedure: Parts needed for this procedure: Upper trimmer mount bracket Support bracket Large fist clamp Tube spacer Large backer plate Carriage bolt (3/8 x 3 inches) Carriage bolt (1/4 x 1-1/2 inches) Flange nut (3/8 inch) Flange nut (1/4 inch)
Page 4
Applying the Decal Securing the Upper Trimmer Mount Assembly Parts needed for this procedure: to the Support Bracket Decal 117-0346 Parts needed for this procedure: Procedure Carriage bolt (5/16 x 7/8 inch) If decal 117-0346 is applied to the right post of the Flange nut (5/16 inch) roll bar on your machine and the support bracket now covers that decal, apply the new decal to the inner,...
Page 5
Installing the Lower Assembling the Trimmer Trimmer Mount Assembly Mount Bracket Parts needed for this procedure: Parts needed for this procedure: Lower trimmer mount assembly Trimmer mount bracket Carriage bolt (3/8 x 1 inch) Fist-mount plate Small fist clamp Flange nut (3/8 inch) Small backer plate Flange nut (1/4 inch) Procedure...
Page 6
Securing the Trimmer Securing a Trimmer to the Mount Bracket to the Lower Mount Assemblies Trimmer Mount Assembly No Parts Required Parts needed for this procedure: Procedure Carriage bolt (1/4 x 3/4 inch) Insert the handle end of the trimmer into the large fist Flange nut (1/4 inch) clamp and the trimming end into the small fist clamp.