Signature Hardware STONE TROUGH CONSOLE SINK Installation Instructions Manual

Advertisement

STONE TROUGH CONSOLE SINK
INSTALLATION INSTRUCTIONS
CONTENTS
2
2
2
3
4
5
6
Stone Trough Console Sink Installation Instructions
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the STONE TROUGH CONSOLE SINK and is the answer not in the manual?

Questions and answers

Summary of Contents for Signature Hardware STONE TROUGH CONSOLE SINK

  • Page 1 STONE TROUGH CONSOLE SINK INSTALLATION INSTRUCTIONS CONTENTS Console Installation Sink Support Backsplash Undermount Sink Semi-Recessed Sink Vessel Sink Drain Installation Stone Trough Console Sink Installation Instructions...
  • Page 2: Sink Support

    For counters with a backsplash, apply silicone to 3. Allow silicone to dry for 24 hours. the backsplash's edge and wall-facing side. Position the backsplash to the rear of the counter and against the wall. Allow silicone to dry. Stone Trough Console Sink Installation Instructions...
  • Page 3: Undermount Sink

    7. Carefully turn the top and sink over. If needed, reposition the sink by slightly loosening the wing bolts and adjusting the placement. Re-tighten the bolts when nished. 8. Remove any excess silicone sealant with a damp cloth. Let silicone dry for 24 hours. Stone Trough Console Sink Installation Instructions...
  • Page 4: Semi-Recessed Sink

    3. Turn the sink back over, placing it inside the sink cutout and position until centered. TOOLS AND MATERIALS: 4. Remove any excess silicone with a damp cloth. Let silicone dry for 24 hours. Neutral Cure Damp Cloth Silicone Sealant Stone Trough Console Sink Installation Instructions...
  • Page 5: Vessel Sink

    2. Turn the sink right-side-up and position it back over the 2” drain hole. TOOLS AND MATERIALS: 3. Remove any excess silicone with a damp cloth. Let silicone dry for 24 hours. Neutral Cure Damp Cloth Silicone Sealant Stone Trough Console Sink Installation Instructions...
  • Page 6: Drain Installation

    6. Slide the friction washer up to meet the rubber gasket. 7. Thread the lock nut onto the threaded shank. Hand-tighten and make sure that the drain is properly aligned. When ready, nish tightening with a basin wrench to secure the drain. Stone Trough Console Sink Installation Instructions...

Table of Contents