Litelume Dusk to Dawn High Power Installation Instructions

Dusk to Dawn High Power
Installation Instructions
Warning
PLEASE READ ALL INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION
1. Turn power off before inspection, installation or removal.
2. The installation should be performed by qualified electricians or lighting technicians.
3. Before conducting any installation, maintenance, or removal, disable all power to the luminaries and wait until the fixture cool
down.
4. Do not touch the fixture while it is in service.
5. If there is any problem with the fixture, DO turn off power and DO NOT attempt repair unless you are a qualified technician or
the customer service member.
Wall Mount Instructions
1. Place mounting section of fixture onto desired mounting surface, mark and drill holes for mounting.
2. Mount the fixture with bolts provided. Install the two bottom screws first. Place the fixture on the two bottom screws and install
the top screw. Tighten the top screw first and then tighten the remaining screws.
3. Make wiring connections in the fixture. (White to Neutral lead, Black to Line lead, Yellow Green to Ground lead)
4. Put the cord protection bracket back on the fixture and fix it with screws provided.
5. Plug the twisted photocontrol or shorting cap into photocontrol receptacle.
6. Installation is completed.
www.litelume.com
info@litelume.com
©Lite Lume Corporation 2018
833.LED.LUME
PHOTOCONTROL
HEATSINK
LENS
Page 1/2 LITELUME™ seeks to deliver the most advanced and efficient LED technology. Due to
technology progression, specifications may change. We reserve the right to update product
Rev Date: 05/3/2019 specifications without notice. Contact LITELUME™ for the most up-to-date data.
PHOTOCONTROL
RECEPTACLE
CORD
PROTECTION
BRACKET
FLAT WASHERS
INCLUDED