Frontgate DOUBLE STEPPING SANTA Quick Start Manual

I. DESCRIPTION

Thank you for purchasing the Double Stepping Santa. This product features a Santa doll with a string of lights over his shoulder climbing up and down his Christmas ladder
helping decorate your tree. Plays 30 Christmas carols. The gift box includes a unit and an adapter. This product is not a toy and is not intended for use by children.

II. SETTING UP THE UNIT

1. Gently lift the unit from the packaging and remove the unit from the polybag.
2. Attach ladder part A into ladder part B [see fig I]
3. Extend ladder bar [see fig II]
4. Attach ladder stablizer [see fig III]
5. Position ladder next to your Christmas tree or on any flat surface. Place the control box on the ground (sleigh) and the
Santa in the middle of the ladder, engaging first one of his hands and then the other with the ladder rails and place one
of his feet on a ladder rung [see fig IV]
6. To make sure the string of lights does not obstruct Santa's foot when he climbs up and down the ladder, place the light
strings' metal ring on the hook located at the rear of the ladder [see fig V]

III. OPERATION

1. Insert the adapter plug into the unit jack at the rear of the control box (sleigh). Plug the adapter into a nearby working outlet.
The adapter is intended to be correctly oriented in a vertical or floor mount position.
2. Turn the VOLUME/ON-OFF dial from OFF to ON. Music will start to play, Santa will begin to climb and the lights will go on.
3. Press the RESET button to hear a different song.
4. Turn the VOLUME dial to adjust the volume of the music.
NOTE: No music can be heard at the MIN setting.
Fig. I
LADDER "B"
UP/DOWN CONTROL SWITCH
Fig. IV

IV. TROUBLESHOOTING

Problem Likely Cause
No power
No music, motion or lights
VOLUME dial OFF
Music is not playing but
Pause between songs
train is moving
Bulbs need to be
Bulbs will not illuminate
tightened or replaced
Music is too loud, too soft VOLUME dial is
or not audible incorrectly adjusted
THIS PRODUCT IS NOT A TOY
DOUBLE STEPPING SANTA
SKU# 46691
Fig. II
LADDER "A"
HOOK
METAL RING
Fig. V
Solution
Make sure the adapter is plugged into a working outlet and the adapter jack is securely attached to the back of the
control box (sleigh)
Turn VOLUME dial from OFF to ON
Wait one or two seconds for the next song to start
a) To avoid electric shock, remove the adapter from the rear of the control box (sleigh)
b) Remove plastic bulb cover by twisting it counter-clockwise.
c) If bulb is loose, tighten by turning bulb clockwise. If bulb needs to be replaced, remove bulb by twisting it
counter-clockwise and then remove bulb from socket [see fig 6]
d) Dispose of defective bulb properly and then install new bulb by twisting it clockwise until tight and replacing
the plastic bulb cover by twisting it clockwise until tight [see fig 6]
Make sure VOLUME dial is at ON and then adjust to your preference
METAL BAR
STABILIZER
VOLUME ON/OFF CONTROL SWITCH
RESET BUTTON
ADAPTOR JACK
Fig. VI
Fig. III
PLASTIC LED COVER
TO TIGHTEN
TO RELEASE
LED
Fig .VII