Page 1
KIT INSTRUCTIONS Base Cable Management Bar 7613-K500 Issue A...
Page 2
NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current.
Base Cable Management Bar Introduction This kit provides a cable management bar for the RealPOS XR3 and RealPOS XR4. Kit Content...
Page 5
7613-K500 (Cable Management Bar) RealPOS XR3 Installation Procedure 1. Lay the terminal face down on a flat surface. Caution: Always use a soft material (cloth, foam) to protect the display screen when placing the terminal face down. 2. To open the I/O Cover, press on the ribs on both sides and then pivot the cover.
Page 6
7613-K500 (Cable Management Bar) 3. Connect the cables to the corresponding connectors and route the cables towards the back of the terminal. 4. Close the I/O Cover. Tighten the cables to avoid them from dangling. 5. Install the Cable Management Bar.
Page 7
7613-K500 (Cable Management Bar) 6. Tighten the thumbscrews (2) to secure the cables.
Page 8
7613-K500 (Cable Management Bar) RealPOS XR4 Installation Procedure 1. Lay the terminal face down on a flat surface. 2. To open the I/O Cover, press on the ribs on both sides and then pivot the cover.
Page 9
7613-K500 (Cable Management Bar) 3. Connect the cables to the corresponding connectors and route the cables towards the back of the terminal. 4. Close the I/O Cover. Tighten the cables to avoid them from dangling. 5. Install the Cable Management Bar.
Page 10
7613-K500 (Cable Management Bar) 6. Tighten the thumbscrews (2) to secure the cables.