Advertisement
2
Installing the Lights
Parts needed for this procedure:
1
Right light
1
Left light (has button switch)
2
Locknut (5/16 inch)
1
Wire harness
1
Fuse (15 amp)
2
Convoluted tube
8
Plastic tie
2
Friction washer
1
Y-Adapter
Procedure
1. Install the convoluted tube onto the exposed wires
connected to the lights.
Note: Use 4 plastic ties on each end of the convoluted
tube to secure it to the wires (Figure 3).
2. Slide the light connectors into the holes in the brackets
(Figure 2).
1. Right light
2. Bracket installed
Note: The lock washer fits inside the friction washer
and centers the friction washer.
Important: Do not overtighten the hardware for
the lights. Gently tighten the nut to secure the
Figure 2
3. Left light (has button
switch)
light and test the friction to move light. Loosen or
tighten the nut to control the friction holding the
light and allowing the light to be aimed.
3. Discard the 2 nuts included with the lights.
4. Install the left-hand light (with the button switch) to
the left bracket with a locknut (5/16 inch), a friction
washer, and a lock washer and bolt include with the
light (Figure 3).
Note: Ensure the light is in place so the friction allows
the light to pivot and swivel.
5. Install the right light to the right bracket with a locknut
(5/16 inch), a friction washer, and a lock washer and
bolt included with the light (Figure 3).
Note: Ensure the light is in place so the friction allows
the light to pivot and swivel.
1. Left light (has button
switch)
2. Locknut (5/16 inch)
3. Lock washer included with
light
4. Friction washer
5. Bracket installed
2
Figure 3
6. Bolt included with light
7. Right light
8. Plastic tie
9. Convoluted tube
Advertisement
