Summary of Contents for Ortega ODWS-1
- Page 1 USER MANUAL ORTEGA DIGITAL WIRELESS SYSTEM ODWS-1 Thank you for purchasing the Ortega DIGITAL WIRELESS SYSTEM. Please read this manual carefully before using this product. Keep the manual for future reference.
- Page 2 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT DISASSEMBLE. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THE APPLIANCE TO RAIN OR MOISTURE.
- Page 3 Warning: Changes or modifcations not expressly Warning: Changes or modifcations that are not expressly approved in writing by B-bird may void the users approved in a written format by Ortega may void the authority to operate this equipment. users authority to operate this equipment.
- Page 4 interference by one or more of the following - Reorient or relocate the receiving antenna. measures: - Increase the separation between the equipment and - Reorient or relocate the receiving antenna. receiver. - Increase the separation between the equipment and - Connect the equipment into an outlet on a circuit receiver.
-
Page 5: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS STORE PLEASE THESE INSTRUCTIONS IN A SAFE PLACE ORTEGA WARNING: BEFORE USING YOUR B-BIRD O2 DIGITAL WIRELESS SYSTEM, CAREFULLY READ THE OPERATING INSTRUCTIONS. 1.Observe all instructions carefully in the O2 manual. 1.Observe all instructions carefully in the manual. - Page 6 100 feet of range without 100 feet of range without any signal dropout. The li-ion any signal dropout. The li-ion batteries make the Ortega batteries help makes the O2 wireless system DIGITAL WIRELESS SYSTEM environmentally friendly. It can last up to 5 hours per charge.
- Page 7 SYSTEM SPECIFICATION SYSTEM SPECIFICATIONS Range >100 feet Line-0-site outdoors.* Latency <5ms Frequency Response 20-20K Hz,+1dB/-3dB THD + Noise <0.05%(1K Hz @-10dbFS) Dynamic Range >103dB A weighted Operating Band 2.4G Hz ISM Worldwide Operating Temperature -10 C to 50 C Sample Rate 24bit/48K Hz uncompressed digital transmission Auto sleep/wake up mode:The transmitter will turn to sleep...
- Page 8 QUICK START DIAGRAM QUICK START DIAGRAM TRANSMITTER RECEIVER 1.Transmitter is plugged into the Guitar (your 1.Transmitter plugs into the Guitar (you instruments), instrument), the receiver is connected to your the receiver plugs into the effects pedal, AMP, Audio, effect pedal, AMP, Audio, etc. etc.
- Page 9 3. Channel Selection: The system‘s preset channel is is in low volume and you have to charge. channel A. After indicating the battery life, the A LED 3.Channel choosing,O2 systems’pre-set channel is will flash. If the transmitter and the receiver are channel A,after showing battery volume the A LED will connected successfully the channel LED ( of the flash,it indicates making pairs,if transmitter and receiver...
-
Page 10: Basic Operation Basic Operation
BASIC OPERATION BASIC OPERATION 1.Power – Slide Switch to turn on/off 1. Power – Slide Switch to turn on/off TRANSMETER/RECEIVER TRANSMITTER/RECEIVER 2.Channel Select - Align TRANSMITTER and 2. Channel Select - Align TRANSMITTER and RECEIVER RECEIVER channels. channels. - Page 11 Click the switch to select a channel (A B C or D). Click the switch to select the channel Follow the diagram below to set up the channel. The Follow the diagram below to set up the channel , audio signal indicator LED will flash to indicate the meanwhile the audio signal indicator LED will flash selected channel.
- Page 12 Four channels Four channels The O2 wireless guitar system has four different The Ortega DIGITAL WIRELESS SYSTEM has four channels, and can use up to 4 pair of systems at the different channels and can operate with 4 active pairs same time.
- Page 13 to two amplifiers or connect to effect pedal and pedal to two amplifiers, you just need to use multiple receivers tuner, you need just use multiple receivers with setting being set to the same channel as your transmitter. up to be the same channel. Receiver O2 Receiver As the system is working with 2.4 GHz, please avoid...
- Page 14 When in charging mode, the A B C D LED will flash When in charging,the A B C D LED will flash orderly, orderly with indicating the battery status. For example: If different LED flash indicate different battery volume. both LEDs, A and B, are solid green and the C LED is you can judge according to the A B C D,for example flashing, it indicates that 2/4 of the battery life is the A B LEDs are in solid green,the C LED is flashing,...
- Page 15 Supportive pickup and musical instrument Pickups and preamp systems O2 wireless system can works for passive guitar The Ortega DIGITAL WIRELESS SYSTEM works with and active pickup, piezoelectric acoustic guitar pickup, passive and active electronics, piezoelectric acoustic piezoelectric violin pickup.
- Page 16 Ortega - a brand of Roland Meinl Musikinstrumente GmbH & Co. KG Musik-Meinl-Str.1 | 91468 Gutenstetten, Germany | www.ortegaguitars.com Designed in Germany | Manufactured in P.R. China...
Need help?
Do you have a question about the ODWS-1 and is the answer not in the manual?
Questions and answers