Device Description - Evolite Splitter 4 User Manual



Device description

Features
> DMX signal distributor with signal booster
> Splitter 4 : 1 input 4 output
> Splitter 8 : 1 input 8 output
> All output are isolated
> Fuse : F-1A/250V PTC
> Power supply : AC 110-240V / 50-60Hz
> Dimensions : 200 x 200 x 70mm
> NW : 1,5 kg
1- Receiver cannot more than 31 units before DMX Distributor.
2- Receiver cannot more than 32 units on one output of the DMX Distributor.
3- Use a terminator on the last receiver with a 120Ω resistor between the pin 2 and pin 3 of the
XLR connector:
o DMX 512 connection
The wires must not come into contact with each other, otherwise the fixture will not work at all or properly. Please note the starting
address depends upon which controller is being used. Only use a DMX cable and 3-pin XLR-plugs and connectors in order to connect
the controller with the fixture or one fixture to another
Connection with the mains.
The earth has to be connected. The device must only be connected with an electric installation carried out in compliance with IEC
standards.
Splitter 4 & 8 user guide Ver. 1.00 Page 7